CarlStahl SL000156 Інструкція з експлуатації - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Кабелі та роз'єми CarlStahl SL000156. CarlStahl SL000156 10 сторінок. Cable gripper

Друкувати сторінку
EN
DE

3 Installation and Application

The attachment and installation of the cable holder may only be carried out by persons with the appropriate
expertise. Wire rope ends represent an increased risk of injury. It is important to ensure that the ends of the wire
ropes are tightly closed and that no individual wires or strands protrude. We recommend, wearing suitable gloves for
protection against injury.
3.1
Check before Installation
Before installing the cable holder, fasteners and attachments, the proper condition of the cable holder and the wire
rope must be checked.
3.1.1
Cable Holder
•
No visible damage from outside.
•
It should not be possible to open the cable holder housing by hand.
•
Smooth running of the spring pressure piece.
•
Proper condition of the cable holder can be checked by looking at the pin.
All three balls have to be seen:
•
A damaged cable holder is not to be used.
3.1.2
Wire Ropes
• Suspension ropes must not be greased or oiled and must be clean and free from corrosion.
• The ends of the wire rope must be tightly united, no individual strands or wires must protrude from
the cable assembly. In this case, the end of the wire rope must be cut off again. We recommend the
use of special wire rope cutter / wire rope pliers.
•
The wire rope must not contain kinks, loops or knots.
•
Damaged wire ropes (protruding wires, kinked ropes, etc.) must not be used.
•
Other rope constructions (deviating from 6x7-WSC), materials and strengths as specified require technical
consultation with the Carl Stahl Technocables Team.
185_05042023
All rights reserved:
Carl Stahl Technocables GmbH
Tobelstr. 2
D - 73079 Süßen
Germany
05042023
Contact
Phone: (+49) (0)7162/9443 - 0
http://www.carlstahl-technocables.de/
Seite 6 von 10