Electrolux ESF 4151 Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Посудомийна машина Electrolux ESF 4151. Electrolux ESF 4151 20 сторінок.
Друкувати сторінкуIndicator lights:
have the following meanings:
salt refilling indicator light, illuminates when the salt
has run out
rinse aid refilling indicator light, illuminates when
the rinse aid has run out
The salt and rinse aid indicator lights are never illuminated
while a washing programme is running even if filling with salt
and rinse aid is necessary.
Phase indicator lights:
illuminates when the washing/rinsing phases are
running
illuminates when the drying phase is running
illuminates when the washing programme has
ended
As soon as you select a washing programme, the phase
indicator lights for that programme will illuminate.
As the programme starts, the phase indicator lights turn off
except for the indicator light of the phase in progress.
Prior to using for the first time
Before using your dishwasher for the first time:
1. Ensure that the electrical and water connections comply
with the installation instructions
2. Remove all packaging from inside the appliance
3. Set the water softener
4. Pour 1 litre of water inside the salt container and then fill
with salt
5. Fill the rinse aid dispenser
Setting the water softener
The dishwasher is equipped with a water softener designed to
remove minerals and salts from the water supply, which would
have a detrimental or adverse effect on the operation of the
appliance.
The higher the content of these salts, the harder your water is.
Water hardness is measured in equivalent scales, German
degrees, French degrees and mmol/l (millimol per litre).
The softener should be adjusted according to the hardness of
the water in your area. Your local Water Authority can advise
you on the hardness of the water in your area.
Water hardness
°TH
°dH
(german degrees)
(french degrees)
51 - 70
91 - 125
76 - 90
43 - 50
37 - 42
65 - 75
29 - 36
51 - 64
40 - 50
23 - 28
19 - 22
33 - 39
15 - 18
26 - 32
19 - 25
11 - 14
4 - 10
7 - 18
< 4
< 7
have the following meanings:
Range
mmol/l
(millimol per litre,
international unit for the
hardness of water)
9,0 - 12,5
7,6 - 8,9
6,5 - 7,5
5,1 - 6,4
4,0 - 5,0
3,9 - 3,3
2,6 - 3,2
1,9 - 2,5
0,7 - 1,8
< 0,7
Option push button "3 IN 1":
equipped with the option 3 IN 1, that allows the use of the "3 in
1" combi detergent tablets.
This function can be selected with all washing programmes.
With the selection of this function the inflow of rinse aid and
salt from each respective supply container is automatically
deactivated and also the indicator lights for salt and rinse aid
are deactivated.
Once selected this option (push button indicator light
illuminated ) it will remain active also for the following washing
programmes, to deactivate the function, press the push button
(push button indicator light off).
The water softener must be set in both ways: manually, using
the water hardness switch and electronically, using the function
push buttons on the control panel.
a) Setting manually
1. Open the dishwasher door.
2. Remove the lower basket from the dishwasher.
3. Turn the water hardness switch to position 1 or 2 (see
table).
4. Replace the lower basket.
The dishwasher is factory set
at position 2.
Adjusting the
water hardness setting
manually
electronically
IV
2
IV
2
IV
2
IV
2
IV
2
III
2
III
1
II
1
I/II
1
I
1
7
This appliance is
AA07
Level indicated
in the
digital display
level 10
level 9
level 8
level 7
level 6
level 5
level 4
level 3
level 2
level 1
Use
of salt
yes
yes
yes
yes
yes
yes
yes
yes
yes
no