Athletica Sport Systems FM-45G Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Морозильна камера Athletica Sport Systems FM-45G. Athletica Sport Systems FM-45G 8 сторінок. Ice puck freezer

Друкувати сторінку
Ice Puck Freezer
Product User Manual
TROUBLESHOOTING
Problem
The compressor runs for 1 to 5
minutes and stops.
The compressor runs but the inner
liner does not get very cold.
The inner liner is very cold and the
compressor runs continuously.
The compressor does not run.
The freezer is noisy.
Can the unit plugged into both AC
and DC power supply?
Cause
The voltage is not in the correct range.
The ambient temperature is too high.
The system is blocked.
The ice layer on the evaporator is too
thick.
The door is being opened and closed too
frequently.
The freezer is overloaded.
The condenser is not well-ventilated.
The temperature sensor- tube is out of
the evaporator or the controller is faulty.
The controller is faulty (the power
indicator is not on).
The thermostat is set too high and the
ambient temperature is too low.
The freezer is not level.
The voltage is not in the correct range.
554 Parkside Drive, Waterloo, Ontario, Canada N2L 5Z4 TEL 519-747-1856
720 Innovation Drive, Shakopee, Minnesota, USA 55379 TEL 763-249-7465
Solution
Switch off the power and restart
when the power is normal.
The operating temperature of this
unit is <90°F. If temperature is higher
than 90°F, the unit will need longer to
cool to the set temperature.
Contact service department via email
Defrost the freezer.
The door should be opened as little
as possible.
Remove some products from the
freezer.
Place the freezer in a well-ventilated
place.
Contact service department via email
Contact service department via email
Set the freezer to a lower
temperature.
Place the freezer on a flat and hard
surface.
Switch off the power and restart
when the power is normal.
Yes. If both AC and DC are plugged
in at the same time, then the unit will
primarily operate on AC. If the AC
power source fails, DC will become
primary source of power supply.