Dreame DreameBot L10 Prime Посібник - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник для Пилосос Dreame DreameBot L10 Prime. Dreame DreameBot L10 Prime 11 сторінок. Robot vacuum and mop with automatic mop cleaning

Друкувати сторінку

Routine Maintenance

Main Brush, Side Brush and Universal Wheel

1. Press the brush guard clips inwards to remove the brush guard and lift the

brush out of the robot.

2. Pull out the brush covers as shown in the diagram. Use a proper tool to

remove the hair tangled in the brush.

3. Remove and clean the side brush.

4. Use a tool such as a small screwdriver to separate the axle and tire of the

universal wheel. Do not use excessive force.

5. Rinse the universal wheel under the running water and put it back after

drying it completely.

Filter

1. Remove the filter and tap its basket gently.

Note: Do not attempt to clean the filter with a brush, finger, or any sharp

objects so as to avoid damaging it.

2. Rinse the dust bin and filter with water and dry them completely before

reinstalling.

Note:

Rinse the dust bin and filter with clean water only. Do not use any detergent.

Use the dust bin and filter only when they are completely dry.

Routine Maintenance

Robot Sensors and Charging Contacts

Wipe sensors and charging contacts of the robot by using a soft, dry cloth:

Cliff Sensors

24h

Note: Wet cloth can damage sensitive elements within the robot and the base

station. Please use dry cloth for cleaning.

Charging Contacts

Clean the charging contacts and the signaling area of the base station with a

soft, dry cloth.

Laser Distance Sensor (LDS)

Edge Sensor

Bumper

Charging Contacts

Mop Pad

Remove the mop pad from the mop pad holder to replace it.

Carpet Sensor

Battery

The robot contains a high-performance lithium-ion battery pack. Make sure

that the battery remains well-charged for daily use to maintain optimal

battery performance. If the robot is not used for an extended period of time,

turn it off and put it away. To prevent damage from over-discharging, charge

the robot at least once every three months.