Forms + Surfaces levele Інструкція з монтажу Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Освітлювальне обладнання Forms + Surfaces levele. Forms + Surfaces levele 7 сторінок. Elevator interiors with lightplane

Друкувати сторінку
LEVELe
ELEVATOR INTERIORS WITH LIGHTPLANE
®
19
SIDE
REAR
Install Panel Clips.
•
Attach the clips as shown, using the
provided self-drilling screws.
See step 9 for detail.
•
One panel clip should be installed every
18-24" for proper alignment.
22
SIDE
REAR
Repeat steps 5-21 for remaining walls.
•
Install all panels for remaining walls as
indicated in previous steps.
T 1.800.451.0410 | F 412.781.7840 | www.forms-surfaces.com
© 2017 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
20
SIDE
REAR
Repeat steps 18-19 as required.
•
No side Panel Clips are installed for last
panel in row.
23
TOP VIEW
Mounting
Extrusion
Cover Extrusion
Installed Panel
REAR
SIDE
Install (2) Cover Extrusions on each wall.
•
Cover the screws and Mounting Extrusion
with the Cover Extrusion provided.
•
The Cover Extrusion is backed with
factory supplied foam tape.
INSTALLATION INSTRUCTIONS
21
TOP VIEW
Mounting
Installed
Extrusion
Panel
REAR
SIDE
Install (1) Mounting Extrusion on remaining
side of rear wall.
•
Position Mounting Extrusion and attach
using provided self-drilling screws.
•
If LightPlane Panels are adjacent to Mounting
Extrusion, the extrusion will need to be cut to
avoid damage to the exit wire(s).
•
Mounting Extrusion must engage fully with
panels.
24
LightPlane Panels
LightPlane Panel
Power Source
Lead with
Quick Connect
Secure LightPlane Panel power source to
cab shell ceiling.
•
Mount the LightPlane Panel power box
securely to the cab shell ceiling.
•
The LightPlane Panel leads will be fed
through an opening in the cab shell
ceiling.
page 5 of 7 | 10-16-17