Carmanah EG320 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Освітлювальне обладнання Carmanah EG320. Carmanah EG320 13 сторінок. Eg-series
Також для Carmanah EG320: Посібник користувача (16 сторінок)

Друкувати сторінку

EG320/EG340 Programmer

The programmer is used to program the EMS with

the correct operating profile for your application. The

programmer is also used to test the EG320/EG340

system to confirm correct operation. The programmer

is powered by two AA batteries (not included), and

communicates with the EG320/EG340 EMS using

two-way infrared signals.

The programmer has two buttons: Send and Test. The

Send button is used to upload the operating profile

(parameters) to the EG320/EG340 EMS, while the

Test button is used to test that the EG320/EG340

system is operating correctly.

The 12 knobs and switches on the programmer

come pre-configured with the correct settings for your

application. If the knobs or switches get moved acci-

dentally, return them to the positions indicated by the

faceplate label.

The EG320/EG340 uses two-way

NOTE

communication between the

programmer and EMS. Therefore

each EG320/EG340 EMS must

be programmed one at a time.

Problems arise when more than

one EMS is in range during

programming.

The programmer has indicator lights and a beeper

to convey status to the user. The following table

summarizes the meanings of the lights and the

beeper:

Feedback

Three short beeps & green OK

light ~5s after pressing/holding

Send button

One long beep & red Error

light ~5s after pressing/holding

Send button

One short beep after pressing/

holding Test button

One long beep & red Error light

immediately after pressing Test

or Send button

EG320/EG340 USER MANUAL

EG 300 PRoGRAMMER

Status

Programming successful

Programming not successful

Test command transmitted

Replace 2 X AA batteries in

programmer