ATI Electronics H6 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Гарнітури ATI Electronics H6. ATI Electronics H6 18 сторінок. Bluetooth wireless headset

Друкувати сторінку

Battery information

Your device is powered by a chargeable battery. The full performance of a new battery's an

achieved only after two or three complete charge and discharge cycle. The battery can be

charged and discharged hundreds of times, but it will eventually wear out.

Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully

charged battery connected to a charger, since overcharging may shorten its lifetime. If left

unused, a fully charged battery will lose its charge over time.

If the headset would be leave unused for a long time, please charge fully and turn off the headset.

To prevent over discharge endangering the battery, you are recommended to charge the

headset fully each month.

Never use any other charger that is damaged.

Turning headset on /off

*Turn on the headset

If the headset is turned off, press and hold MFB for 2 seconds until you hear a melody from low to

high, the headset turns on, the Blue indicator light will flash 3 times at the same time.

*Connects to the phone

1.If your headset has finished the pairing operation successfully, when the headset is turned on,

it will connect to the phone(s) you last connected automatically, but make sure your phone's

Bluetooth function is active.

2.The headset supports multi-point and connects to 2 phones at the same time. In some

operations, you need to distinguish the connection sequence, so we appoint the phone first

connected as phone 1, the second one as phone 2.