Using the Up or Down buttons on the OBUI, the following menu items will appear:
Menu Items
LED Fault
Battery Status
Solar Status
Flash Pattern
Input Type
Flashing Duration
Intensity (LED Driver
Current)
Night Dimming
Ambient Auto-Adjust
Automatic Light
Control (ALC)
LED Temperature
Internal Calendar
Radio Enable
Radio Channel
Radio Detection
Status
Digital Output
Push Button Input
Status
LED Fixture Test
Built-In Self-Test
Firmware Version
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |
EMS On-Board User Interface Settings Overview
Broadcast
User-
to other
adjustable
systems?
NO
NO
NO
NO
NO
NO
YES
NO
YES
NO
YES
YES
YES
NO
YES
YES
YES
YES
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
NO
NO
YES
NO
NO
NO
YES
NO
YES
NO
NO
NO
E/F SERIES QUICK START GUIDE
Setting Description
Not normally visible, only appears when the EMS
detects an LED fault.
Reports battery voltage and status
Reports solar panel voltage and status
Indicates the flash pattern currently set
Indicates input mode, NC for 24/7 operation, bttn for
momentary button input, and NO for calendar setting.
For crosswalks, reports the time duration for a flash
pattern.
Indicates the intensity (in milli-amps) the LED modules
are set to use. Higher numbers mean brighter lights.
Indicates what fraction of the daytime intensity the
LEDs are set to at night.
If enabled, automatically dims LEDs on overcast days
up to 50% to prevent glare for drivers.
If enabled, automatically dims LEDs in response to
unexpected solar deficiency to preserve battery life.
If enabled, adjusts LED power output to account for
the effects of environmental temperature variations.
Allows LED loads to be set to turn on and off according
to a time schedule programmed using Carmanah
calendar programming software
Turns the radio on or off
Allows channels to be changed to overcome radio
interference issues on a per unit basis.
Confirms whether a radio module has been detected
by the system controller (EMS).
Used for relay control. Can be adjusted to allow
external loads to be switched on at any time, or only at
night.
Detects the status of the push button input and
whether there are any faults found.
Allows the LED loads to exhibit a test flash sequence.
Allows the system to run a number of self-tests and
can be used for troubleshooting purposes.
Displays the firmware version programmed on the
system controller (EMS).
18
|
carmanah.com
Друкувати сторінку