ATI Technologies AT6000 SIGNATURE SERIES Посібник користувача - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач ATI Technologies AT6000 SIGNATURE SERIES. ATI Technologies AT6000 SIGNATURE SERIES 12 сторінок. Pure balanced 2 to 7-channel power amplifier signature series
Друкувати сторінку
Power Amplifier Specifications
Series
Number of Channels
EIA 1kHz Output Power at 8 Ohms*
EIA 1kHz Output Power at 4 Ohms*
FTC Full Bandwidth Output Power at 8 Ohms**
FTC Full Bandwidth Output Power at 4 Ohms**
Input Sensitivity for Full Rated Power
Frequency Response at Rated Output
Phase Response
Signal-to-Noise Ratio "A-Weighted"
Total Harmonic Distortion (THD)
Intermodulation Distortion (IMD)
Load Impedance
Power Bandwidth FTC
Damping Factor
Crosstalk
Gain
Slew Rate
Input Impedance
Remote Trigger Voltage
DC Output Offset
Power Requirements
Chassis Dimensions (H x W x D) Inches
Chassis Dimensions (H x W x D) mm
Net Weight (lbs/kg) Model Dependent
Shipping Weight (lbs/kg) Model Dependent
*EIA 1kHz Power refers to maximum average power in watts at 1 kHz with 0.01% THD and noise.
**FTC Full Bandwidth Power refers to maximum average power in watts from 20Hz to 20 kHz with 0.05% THD and noise.
The contents of this manual are Copyright © 2014 by Amplifier Technologies, Inc. and may not be duplicated or reproduced by
Any means, whether physical, electronic or otherwise without prior written consent from Amplifier Technologies, Inc.
Specifications are those in effect at the time of printing. Amplifier Technologies, Inc. reserves the right to change
specifications or designs at any time without notice.
Page 11
+5 to -15 degrees from 20Hz to 20kHz at 1 watt
Greater than 128dB below rated FTC Full Bandwidth Output
Less than 0.05% at full rated FTC power; Less than 0.01% at full EIA power at 1kHz
Less than 0.05% at full rated FTC power; Less than 0.01% at full EIA power at 1kHz
Safe with all types of loads. Rated for 4 to 16 ohms
Greater than 400 from 10 Hz to 400 Hz
Greater than –80 dB from 20 Hz to 20 kHz
3.3 to 24 Volts DC at 5 mA or greater
120 VAC (other voltages available on export models)
9½ x 17¼ x 18½ (Without feet: H = 8¾)
241 x 438 x 470 (Without feet: H = 222.25)
Handles protrude 1¾" (44.5 mm); Add 1¼" (32 mm) for input/output jacks
AT6000
2 to 7
350 Watts
450 Watts
300 Watts
450 Watts
1.95 Volts
20Hz to 20kHz ±0.1dB
+0, -3 db from 5 Hz to 80 kHz
Voltage gain of 28dB ±0.2 dB
>60 V/µs
Nominally 50 kΩ
Less than ±5 mV
86 to 136.4 / 39 to 62
96 to 146.4 / 43.6 to 65.5