Dreaming Robots Camera Axe 5 Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари для фотоапаратів Dreaming Robots Camera Axe 5. Dreaming Robots Camera Axe 5 20 сторінок.

Друкувати сторінку
Interval
# Shots (0=Inf)
Bulb (sec)
HDR Stops
Mirror Lockup
An example of how this might be used:
Parameter
Start Delay
Interval
# Shots (0=Inf)
Bulb (sec)
HDR Stops
Mirror Lockup
This would trigger a total of 8 shots. The first one would be after 5 seconds with a 1 second shutter
hours:minutes:seconds
Numeric value between
0000 and 9999
Numeric value between
000.0 and 999.9
Numeric value between
0 and 9
Yes
No
Options
00:00:05
00:01:00
2
001.0
3
No
The amount of time between shots in hours,
minutes and seconds.
The total number of intervals that will be
done. Setting this to 0 will take keep taking
shots until this mode is exited or the Camera
Axe runs out of batteries.
How long the camera/flash will be triggered
during each interval. Many Cameras have a
minimum duration for this triggering.
This determines the number of "extra"
shots that are taken during an interval. For
example, a value of 0 will take one shot
during each interval. A value of 2 will take
three shots during each interval. The "HDR"
is accomplished by doubling the bulb time for
each shot (see the example below). For this
mode to work your camera must be in "bulb"
mode.
This adds another shutter trigger for each
shot. To use this your camera must support
mirror lockup and have that setting enabled.
The camera is triggered to raise the mirror
and then two seconds later (to allow the
vibration to settle) there is another shutter
trigger to take the shot. This works with the
camera in mirror lockup mode for cameras
that require two shutter presses to take the
shot in mirror lockup mode. In this mode, the
mirror lockup shutter trigger is ½ second plus
the 1.5 second delay.