Electrolux 10 GN2/1 Посібник з монтажу - Сторінка 21

Переглянути онлайн або завантажити pdf Посібник з монтажу для Морозильна камера Electrolux 10 GN2/1. Electrolux 10 GN2/1 34 сторінки. Electrical combi oven, touch and digital
Також для Electrolux 10 GN2/1: Посібник (3 сторінок)

Друкувати сторінку

E.1

Introduction

WARNING

Refer to "WARNING and Safety

Information".

To ensure correct operation of the appliance and maintain safe

conditions during use, carefully follow the instructions given in

this chapter.

Check and, if necessary, level the appliance after positioning.

Incorrect levelling can cause appliance malfunctioning.

E.2

Installation in Australia

IMPORTANT

This appliance shall be installed only by authorised

persons and in accordance with the manufacturer's

installation instructions, local gas fitting regulations,

municipal building codes, electrical wiring regula-

tions, local water supply regulations, AS5601-gas

installation, health authorities and any other stat-

utory regulations.

E.3

Customer's responsibilities

The tasks and works required of the Customer are:

• check the floor planarity on which the appliance is placed;

• arrange an earthed power socket of suitable capacity for the

input specified on the data plate;

• prearrange a high-sensitivity manual-reset magneto-ther-

mal circuit-breaker;

• prearrange a device lockable in the open position for the

connection to the power supply.

NOTE!

For information regarding the electrical connection,

refer to "A.8 Electrical connection".

E.4

Installation

E.4.1

Unpacking

1. Remove the copper staples and the cardboard from the

appliance;

2. Cut the plastic straps fixing the appliance to the pallet;

3. Lift the appliance with a lift truck, remove the pallet and

position the appliance in the place of use;

Remove the protective film, taking care not to scratch the

surface if scissors or blades are used;

E.4.1.1 Transport of the appliance

• Keep the device's barycenter in mind to prevent it from

tipping over.

• If you use the lift truck, keep also in mind the required

spaces and the entrance dimensions.

The minimum entrance dimensions are:

IMPORTANT

Make sure not to damage the drain when removing

the appliance from the pallet.