ATI Technologies B12-69 Посібник з експлуатації та обслуговування - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник з експлуатації та обслуговування для Передавач ATI Technologies B12-69. ATI Technologies B12-69 20 сторінок. 2-wire wet oxidant gas transmitter
Друкувати сторінкуModel B12-69 Wet Oxidant Gas Transmitter
DIGITAL DISPLAY OPTION
Series B12 transmitters supplied with the optional LCD have the display mounted to the
enclosure cover with a clear lens protecting the display from dirt and moisture. The display is connected
to the cover with a short ribbon cable soldered to the transmitter circuit board. The digital display is
factory scaled to the transmitter range specified on the order. The LCD option is not available on
explosion-proof transmitters.
The LCD indicates gas concentration directly in PPM or % depending on the range. It is directly
in the 4-20 mA output circuit so that it is a very accurate indicator of the signal being transmitted to
remote equipment. The display should be used for zeroing and calibration instead of the test points
described in the calibration section of this manual.
When removing the cover of a transmitter with the LCD, be careful not to pull on the display
interconnect cable. When you remove the cover, it can be temporarily fastened to the enclosure base as
shown in Figure 9.
Figure 9 - Transmitter Controls & Test Points (ATI-0227)
O & M Manual
Rev-G, 7/15
- 14 -