Andersen 82-3ST Посібник з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Лебідки Andersen 82-3ST. Andersen 82-3ST 12 сторінок.

Step 2 Prepare the mounting surface

After confirming the mounting location and orientation of the winch,

clean the mounting surface and place the drilling template in the

required position on the deck. Ensure that the surface is flat and

there is adequate space and clearance below deck for access to

mounting bolts.

With the drilling template in the desired orientation, drill the

Ø12.5mm holes for the M12 mounting bolts.

Clean any wood or fibreglass splinters from the holes, and clean the deck thoroughly to ensure

deck sealant can adhere properly. Apply sealant to the deck around the mounting bolt locations,

taking care not to block the drainage grooves in the winch base. For aluminium boats use a

galvanic isolating ring/gasket.

Step 3 Install the winch

Use a hex key to remove the screws at the top of the winch, then lift off the self-tailing arm and

the drum to expose the centre stem, base and gears.

Note that it is not necessary to completely disassemble all components shown in the diagram in

order to install the winch.

Position the winch base on the deck in the desired orientation,

with mounting holes aligned, and secure it to the deck using

appropriate length M12 bolts, large washers or backing plate,

and locking nuts.

See the exploded view for guidance.