ATiB 2SPM Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Контролер ATiB 2SPM. ATiB 2SPM 12 сторінок.
Друкувати сторінкуDipswitch battery voltage
setting on the electronic board
Quick Test
Equalisation /
preservation
Voltage battery (V)
The operation must be made with the electrical power disconnected.
1.
Put the Battery Charger in a suitable place, allowing an adequate air change.
2.
Connect the plugs, being very careful in earthling the AC side. Do not invert the battery polarity in comparison with the
Battery Charger.
3.
Check the data on the charger identification plate, they must correspond with the mains and battery data.
4.
Check the power cables and the battery are well earthen.
5.
Check there are no short circuits on plugs and cables.
6.
Connect the plug to AC mains.
7.
Connect the battery plug.
8.
Push the start button.
The maintenance schedule depends on use and operating conditions but, generally, it should not exceed three months.
The maintenance operations have to be made by specialised personnel, in compliance with safety rules.
Please, follow the instructions in paragraph 4.1 "Put the equipment out of service"
4.1
Put the equipment out of service
When you want to do a routine or extraordinary maintenance on your Battery Charger, or you do not want to use it for a
long time or there is a fault, you must keep it out of service.
Please follow these instructions:
1.
Switch off the Battery Charger
2.
Rotate the AC mains switch in "off" position and disconnect the plug.
3.
Disconnect the battery plug.
Should you wish not to use your Battery Charger for a time, please do not expose it to heat or atmospheric agents, but
keep it in a dry, safe place. The AC main plug and the battery plug must be raised from the ground and secured.
4.2
Routine Maintenance
1.
Clean carefully the AC and battery cables. Check they are not damaged or burnt. In this case, replace them
immediately.
2.
Check the AC mains and battery plugs. If they are crushed or burnt or damaged, replace them immediately.
3.
Electrical equipment must not be exposed to dust and humidity. Clean the Battery Charger. Should it be too dirty or
damp, put it in a safer place.
4.3
Extraordinary Maintenance
1. Follow the checklist of "Routine maintenance".
2. Open the Battery Charger. Clean carefully the dust, on the printed circuits by a clean brush, on the other components
by a blow of compressed air; stay at 20 cm (8 inch) at least.
3. Check the screws and electrical connections are well tightened.
4. Check the fuses, the fuse holders and the moving mechanical parts (contactor
www.atibelettronica.it
1
2
3
4 5 6
Yes
No
Yes
No
12
24
36
48
60
72
80
96
3. INSTALLATION
4. MAINTENANCE
Jumper insterted
uninterested
).
EN
3