Andersen E Series Заміна - Сторінка 3

Переглянути онлайн або завантажити pdf Заміна для Замки. Andersen E Series. Andersen E Series 5 сторінок.
Також для Andersen E Series: Посібник користувача (15 сторінок), Посібник із застосування (2 сторінок)

Interior

Lift blind panel out of window sash. Lay on a clean flat surface with the

interior surface face down. Position panel on table so that the control

knob is hanging over table edge. Failure to do so could result in panel

damage.

Interior

Insert flat blade screwdriver between blind panel frame and blind head

rail and pry. Repeat at locations of mounting clips as necessary to

release blind assembly.

Interior

Feed plastic tassels through the blind cord hole one at a time. Dispose

of blind properly.

9069265

Control knob hanging over

edge of table

Flat Blade Screwdriver

Blind Panel Frame

Blind Head Rail

Plastic Tassels

Blind Cord Hole

Interior

Disconnect the tilt control cable from the D-rod located along the top

side of the panel using .050" hex key.

Interior

The grommet is split to allow it to

be removed from the cords.

Remove blind panel frame cord from blind panel frame.

Tilt Control Knob Cable

Interior

Insert tilt control knob cable and cords from new blind through the holes

in blind panel frame.

Tilt Control Cable

.050" Hex Key

D-rod

Blind Panel

Frame Grommet

Blind Panel Frame

Blind Cords