Bosch Instructions for Use Інструкція з експлуатації - Сторінка 2

Друкувати сторінку

Bosch Instructions for Use Інструкція з експлуатації

Installation

Care and cleaning

Heat exchanger

– Scope of delivery: dryer, installation and operating instructions.

The dryer's heat exchanger is cleaned automatically during drying. Cln appears in the display

– Check dryer for transport damage.

panel. Do not pull out the condensation container during the cleaning process.

– The dryer is very heavy. Do not attempt to lift it on your own.

– Be careful to avoid sharp edges.

Dryer housing, control panel, air intake

– Do not set up in a room that is susceptible to frost. Freezing water may cause damage.

Wipe with a soft, damp cloth.

– If in doubt, have the appliance connected by a specialist.

Do not use harsh cleaning agents or solvents.

– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.

Remove detergent and cleaning agent residue immediately.

Some water may collect between the window and the seal during drying. This does not affect

Setting up the dryer

Take all accessory parts out

the proper operation of your dryer in any way.

of the drum.

– The appliance plug must always be accessible.

The drum must be empty.

Filter in the condensation container

– Ensure that the appliance is installed on a clean, level

and firm surface.

The filter is cleaned automatically when the condensation container is emptied.

– Do not obstruct the air inlet on the front of the

However, the filter should still be cleaned regularly under running water

dryer.

stubborn deposits/dirt from building up.

– Keep the area around the dryer clean.

– Make the dryer level using the threaded feet

and a spirit level.

1. Pull out the condensation container.

– Do not remove the threaded feet under any

circumstances.

2. Pull the filter out of its snap-in lock.

Do not set up the dryer behind a door or sliding

door, as this may obstruct the dryer door or prevent

it from opening. This will prevent a potentially fatal

danger to children from locking themselves in.

Clean and level

Make sure that the air inlet

remains unobstructed

3. Clean the filter under running water or in the dishwasher.

Mains connection

see Safety instructions

page 13.

– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.

– The mains voltage and the voltage shown on the rating plate (

page 10) must be the

same.

– The connected load and necessary fuse protection are specified on the rating plate.

Frost protection

Do not operate the dryer if

4. Refit the filter.

there is a danger of frost.

Preparation

5. Insert the condensation container so that it locks into place.

1. Empty the condensation container

page 4.

2. Select any programme using the programme selector.

Only operate the dryer with the filter inserted.

3. Press the

Start/ Stop button

condensed water is pumped into the container

4. Wait 5 minutes and then empty the condensation container again.

Moisture sensor

5. Turn the programme selector to Off .

The dryer is equipped with stainless steel moisture sensors. Moisture sensors measure how

Transport

damp the laundry is. A thin layer of limescale may build up on the moisture sensors after

prolonged use.

1. Open the door.

– Prepare the dryer

see Frost protection.

2. Clean the moisture sensors using a damp sponge with a rough surface.

– Transport the dryer in a vertical upright position.

– Following transportation, do not use the dryer for two hours.

Do not use steel wool or abrasive materials.

The dryer contains residual water;

this can flow out if the dryer is tilted.

Appliance must be switched off.

Technical data

Dimensions (DxWxH)

60 x 60 x 85 cm (height adjustable)

Weight

approximately 51 kg

Max. capacity

7 kg

Condensation container

4.0 l

Connection voltage

220-240 V

Connected load

max. 1000 W

Fuse protection

10 A

Ambient temperature

5 - 35 °C

Product number

under the door

Production number

This prevents

The rating plate can be found on the back of the dryer.

Consumption rates

These are guide values determined under standard

conditions.

Spin speed

Drying time

Energy

in rpm

in min.**

consumption

(residual moisture)

in kWh**

Cottons 7 kg

Cupboard Dry*

1400 (approx. 50 %)

128

1.62

1000 (approx. 60 %)

149

1.90

800 (approx. 70 %)

169

2.19

Iron Dry*

1400 (approx. 50 %)

1.13

1000 (approx. 60 %)

113

1.42

800 (approx. 70 %)

133

1.70

Easy-Care 3.5 kg

Cupboard Dry*

800 (approx. 40 %)

0.57

600 (approx. 50 %)

0.72

*Test programs according to DIN EN 61121

**The values may differ from those given, depending on overvoltage and undervoltage, the

type of fabric, composition of the laundry to be dried, the residual moisture in the fabric and

the size of the load.

Drum interior light

(depending on model)

(bulb E14, 25 W)

The drum lights up after the door is opened or closed, and after the programme starts, and

switches off automatically. Changing the bulb

page 12.

Optional accessories

(from after-sales service using order number)

Washer-dryer stack connection set

WTZ

11310

The dryer can be placed on top of a suitable washing machine with the same width and depth

to save space. The dryer must be fastened to the washing machine using this connection set.

WTZ

Same as WTZ 11310, but with pull-out worktop.

11300

Installation underneath the worktop

WTZ

10290

Instead of the appliance covering plate, you must have a metal cover fitted by a specialist.

Normal noises

What to do if...

If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales

During drying, the compressor and the pump generate some noise which is entirely normal.

service. We will always find an appropriate solution and will avoid unnecessary visits by

engineers. Trust the expertise of the manufacturer and rest assured that the repair will be

carried out by trained service technicians using original spare parts. The contact details of your

local after-sales service can be found in the enclosed after-sales service directory, or by calling

one of these numbers:

– GB 0844 8928979 (Calls from a BT landline will be charged at up to 3 pence per minute.

A call set-up fee of up to 6 pence may apply.)

The compressor in the dryer may

– IE 01450 2655

occasionally generate a humming noise.

When contacting the after-sales service, please quote the appliance's product number (E no.)

and production number (FD) (see under the loading door).

Turn the programme selector to Off and unplug the mains plug from the socket.

The

Start/Stop indicator lamp

does not light up.

The Container indicator lamp

and the

Start/Stop button are

flashing.

The Filter indicator lamp and

Start/Stop button are flashing.

Cln appears in the display panel. Not an error. Automatic cleaning of the heat exchanger.

The compressor in the dryer is ventilated

from time to time, which creates a whirring

Dryer does not start.

sound.

Water is leaking out.

The door opens by itself.

Creasing.

Drying result is not satisfactory

(laundry feels too damp).

The automatic cleaning process causes

a clicking noise.

Drying time too long.

The humidity in the room

increases significantly.

Power failure.

The process of pumping the condensation

into the condensation container generates

Other intermittent noises

pumping noises.

and vibrations.

Loud humming noise for several

seconds.

The interior light is not working

(depending on model).

Safety instructions

Emergency

– Pull the appliance plug out of the socket immediately or disconnect the fuse.

ONLY use the

– in rooms inside the house.

dryer...

– to dry fabrics.

The dryer must

– be used for purposes other than those described above.

NEVER...

– be modified in terms of its technology or properties.

Hazards

– The dryer must not be used by children or persons who have not been

instructed in its use.

– Do not leave children unsupervised near the dryer.

– Keep pets away from the dryer.

– Remove all objects from pockets,

and lighters in particular

Risk of explosion.

Mains plug plugged in?

– Do not lean or sit on the door

Risk of tipping.

Programme selected?

Installation

– Secure loose cables

Risk of tripping.

Empty the condensation container

page 4.

– Do not operate a dryer if there is a risk of frost.

Clean the condensation container filter if necessary

Mains

– Connect the dryer to an AC earthed socket according to specifications,

page 9.

connection

otherwise it cannot be guaranteed that the appliance is completely safe.

Dryer transported?

Wait 2 hours and start again.

– The cable cross-section must be sufficient.

Rinse the fluff filter under running water

page 4.

– Only use earth-leakage circuit breakers with the following symbol:

– The appliance plug and socket must be compatible.

– Do not use multiple plugs/connectors and/or extension cables.

Do not empty the condensation container.

– Do not touch or hold the appliance plug with wet hands

Start/Stop button selected?

Risk of electric shock.

Door closed? Programme set?

– Never pull the appliance plug out of the socket by its cable.

Ambient temperature greater than 5 °C?

– Do not damage the mains lead

Risk of electric shock.

Make sure the dryer is level.

Operation

– Only load the drum with laundry.

Push the door closed until you hear it click into place.

Check the contents before you switch the dryer on.

– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,

Laundry load exceeded?

grease or paint (e.g. hair styling products, nail varnish remover, stain remover,

Remove articles of clothing immediately after the end of the

cleaning solvent, etc.)

Risk of fire/explosion.

programme, hang up and pull into shape.

– Dust (e.g. coal dust, flour) poses a danger: Do not use the dryer

Unsuitable programme selected

page 7.

Risk of explosion

Warm laundry feels damper than it actually is.

– Do not put laundry containing foamed material/rubber in the dryer

The selected programme does not suit the load. Use

material may be destroyed and the dryer be damaged due to possible

another drying programme or, in addition, select the time

deformation of the foamed material.

programme

page 7.

– When cleaning the fluff filter, make sure that no foreign material (down or filling

Use fine adjustment for the drying result

page 1/2 and 6.

material) gets into the air duct opening. If necessary, clean the drum

Fine layer of limescale on the humidity sensors

beforehand with a vacuum cleaner. If foreign material should still get into the

Clean the humidity sensors

page 9.

air duct

call the after-sales service

Risk of fire/explosion.

Programme termination, e.g. tank full, mains power supply

– Switch off the dryer once the programme has ended.

failure, door open or maximum drying time reached.

– The water from condensation is not drinking water and may be contaminated

Rinse the fluff filters under running water

page 4.

with fluff.

Insufficient supply of air

ensure that air can circulate.

Air inlet possibly blocked

Clear inlet

page 8.

Defect

– Do not use the dryer if it is defective or if you suspect that it is.

Ambient temperature higher than 35 °C

ventilate the

Repairs must only be carried out by the after-sales service.

room.

– Do not use the dryer if the mains cable is defective. To avoid danger, only have

Make sure the room is sufficiently ventilated.

the defective mains cable replaced by the after-sales service.

– Always pull the mains plug out of the socket before changing the bulb for the

Remove laundry from the dryer immediately and spread out.

interior light

Risk of electric shock.

This allows the heat to dissipate.

Spare parts

– Only use genuine spare parts and accessories for safety reasons.

Not an error.

Disposal

– Pull out the appliance plug, then cut off the mains cable from the appliance.

Normal noises

page 11.

Dispose of at a municipal waste disposal facility.

Has the condensation container been properly inserted?

– Heat exchangers contain a fluorinated greenhouse gas covered by the Kyoto

Push the condensation container all the way in.

protocol (R134a)

dispose of in a proper manner. Capacity: 0.22 kg.

Not an error. Normal noises

page 11.

– Packaging: Keep all packaging out of reach of babies and children

Pull out the appliance plug, remove the cover cap in the

Risk of suffocation.

interior above the door (use Torx 20 screwdriver) and

– All materials are environmentally sound and can be reused. Dispose of in an

replace the bulb

page 10. Close the cover cap.

environmentally-responsible manner.

Never operate the dryer without a cover cap.

elastic

Dryer

en Instruction manual