Bosch Instructions for Use Інструкція з монтажу Посібник з монтажу - Сторінка 8

Друкувати сторінку

Bosch Instructions for Use Інструкція з монтажу Посібник з монтажу

INSTALLATION INSTRUCTIONS

Ins tallation in structio ns

PLQ

: Important safety information

Read these instructions carefully. Only then

will you be able to operate your appliance

safely and correctly. Retain the instruction

manual and installation instructions for

future use or for subsequent owners.

The appliance can only be used safely if it

is correctly installed according to the safety

instructions. The installer is responsible for

ensuring that the appliance works perfectly

at its installation location.

The width of the extractor hood must

correspond at least with the width of the

hob.

For the installation, observe the currently

valid building regulations and the

regulations of the local electricity and gas

suppliers.

Danger of death!

Risk of poisoning from flue gases that are

drawn back in.

Always ensure adequate fresh air in the

room if the appliance is being operated in

exhaust air mode at the same time as room

air-dependent heat-producing appliance is

being operated.

[

This appliance is installed on the wall.

■

Follow the enclosed installation instructions for additional

■

special accessories (e.g. for circulating-air mode).

The surfaces of the appliance are sensitive. Avoid damaging

■

them during installation.

Room air-dependent heat-producing

appliances (e.g. gas, oil, wood or coal-

operated heaters, continuous flow heaters

or water heaters) obtain combustion air

from the room in which they are installed

and discharge the exhaust gases into the

open air through an exhaust gas system

(e.g. a chimney).

In combination with an activated vapour

extractor hood, room air is extracted from

the kitchen and neighbouring rooms - a

partial vacuum is produced if not enough

fresh air is supplied. Toxic gases from the

chimney or the extraction shaft are sucked

back into the living space.

Adequate incoming air must therefore

■

always be ensured.

An incoming/exhaust air wall box alone

■

will not ensure compliance with the limit.

[