Community C SERIES CP6 Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу для Спікери Community C SERIES CP6. Community C SERIES CP6 8 сторінок. Pendant loudspeaker 6.5" full-range

Друкувати сторінку

Installation and Wiring

Before inserting cables into the Gripples, attach both snap hooks to the

suspension bracket atop the loudspeaker as shown in Figure 1. Attach the main

cable to the center hole, and the safety cable to either of the two outer holes

depending on the desired orientation. Make sure the spring-loaded safety hook

is positioned as shown so it closes the loop to prevent accidental detachment.

Note: Two 15-foot cable kits with Gripple Speed Clamps are included; longer kits are

available in the Optional Accessories section.

Thread the plain ends of the main cable and safety cable up through the

loudspeaker top cover as shown in Figure 2.

For clarity in Figure 3 the loudspeaker and its cover are not shown, but these

should actually be in place per Figures 1 and 2. Refer to Figure 3 for the following

steps:

1. Beginning with the main support cable, insert its plain end through the

Gripple Speed Clamp. Loop the cable over (or through) the ceiling anchor

point, thread the plain end back through the Gripple and pull that cable end

so that the hook is hanging a little lower than where you think you'll want the

loudspeaker's attachment point to be located.

2. Repeat this with the safety cable and Gripple, looping the cable over or

through an independent attachment point.

3. Support the loudspeaker with your hand at the desired height.

4. Pull the end of the main cable to take up any slack.

5. Pull the end of the safety cable to take up any slack. See Figure 6 for further

height adjustments.

CAUTION: Do NOT pull the cables to raise the loudspeaker.

Page 4

Plain Cable Ends

Snap-Hook Ends

Figure 2. Thread cables through the

loudspeaker cover

Installation Guide

Safety Cable

Main Cable

(center)

Figure 1. Support and safety cable

placement

Figure 3. Hang the loudspeaker using

Gripples

C SERIES - CP6