Community Distributed Design DS8SUB Посібник з монтажу та експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Спікери Community Distributed Design DS8SUB. Community Distributed Design DS8SUB 12 сторінок. Distributed design series surface mount loudspeakers
Також для Community Distributed Design DS8SUB: Встановлення та експлуатація Посібник користувача з технічного обслуговування (12 сторінок)

Vertical mounting

5. Adjust the cabinet position by rotating and

tilting as desired. Then firmly tighten the locking

screw with the provided hex wrench.

Horizontal mounting

Horizontal Mount Maximum Aiming Angle

DS5

8°

20°

64°

Vertical Mount Maximum Aiming Angle

DS5

39°

31°

Note: This enlarged label shows the

70-volt/100-volt and 8-ohm power tap settings

for the DS8. With 100-volt distribution, do

not use the N.C. setting.

Distributed Design Series

Surface Mount Loudspeakers

6. Using a small slot-blade screwdriver (like the

one provided) you can pry the logo plate out a

few millimeters, then rotate it 90° and press it

back in place so it reads correctly for horizontal

or vertical mounting.

7. Once you have connected the wiring (next

page), you can also remove the logo plate for

access to the recessed tap-adjustment screw

DS8

which you can use to set the power level for the

8°

individual loudspeaker as shown below.

11°

59°

DS8

39°

33°

Installation and Operation Manual

Note: The tap switch can only

adjusted

using

screwdriver such as the one provided

with the loudspeaker.

flat-blade

Page 8