Operation
Using the dryer
1. Open the door.
2. Check lint filter.
The filter should be cleaned
after and before every drying
process.
Cleaning the filter
reduces the drying time and
saves energy.
Start
O
)
3. Rotate program
selector to the
desired program.
Select the program
which
corresponds
to the laundry in
the dryer from the program
selection
table (see page 23).
The Start/Stop
indicator light starts
flashing.
ITllf
lint filter indicator flashes -
Check lint filter!
_tart
Low
Wr nkle
heat irentng
_ bIockiEnd
L Filter
%
4. If required,
select Low heat
by pressing the button.
The Options are explained
on page 15,
5. If required,
select Easy ironing
by pressing the button.
The Options are explained
on page 15.
6. Place laundry in the empty
,
,
%
drum, Put each piece of laundry
into the machine separately.
For best results the laundry
to be dried must be sorted
according
to type of laundry
and desired degree of drying.
Observe drying symbols of the
laundry manufacturer.
Ensure that there is only
laundry in the drum. Check that
all items are completely
in the
drum and that none are caught
between the door and the dryer
housing or door seal.
Close the door.
If the door has not been closed
properly, the dryer will not start,
Start
9. Press the Start/Stop
button.
The Start/Stop
indicator
light
illuminates.
Low
heat ilon ng
O
O
f,-
,,,
%
%
At program
end the LED
Wrinkle
block/End
flashes.
When the drying process is
complete
(program
or selected
time program
ended), the drum
rotates at specific intervals.
This prevent the laundry from
creasing (see Easy ironing,
page 15).
10. Open the door.
11. Take the laundry out of the
dryer.
12. Rotate the program
selector to
Off. The dryer light goes out,
13. Clean the filter.
The filter should be cleaned
after each drying process.
Cleaning the filter reduces the
drying time and saves energy.
14. Close the door.
16
Друкувати сторінку