Community R.35COAX Посібник з монтажу та експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Спікери Community R.35COAX. Community R.35COAX 13 сторінок. R series
Також для Community R.35COAX: Посібник з монтажу та експлуатації (17 сторінок)
Друкувати сторінку
MOUNT THE LOUDSPEAKER
The factory yoke uses threaded studs
and a nut / lock washer / flat washer
combination rather than bolts. This makes
it easier to attach the loudspeaker to the
yoke after the yoke is mounted to the
support structure.
__Attach the loudspeaker to the yoke.
See Figure 3. Screw an 8mm stud into
each side of the loudspeaker so that it
protrudes about 3/4" (19mm). Place the
rubber washers on the studs and then lift
the loudspeaker into place between the
yoke arms. Attach as shown. Support the
enclosure until both sides are secured.
Tighten bolts to finger tight (enough to hold
the loudspeaker in position).
__Determine the approximate angle of
downward tilt. It must be angled at least
5° down from horizontal to maintain the
stated enclosure IP55 rating. Tighten the
hex nuts until sufficiently tight enough to
hold the angle.
IMPORTANT: The loudspeaker is not
designed to be rotated 90° or mounted
upside-down.
Doing
water pooling in the safety cable recess,
compromising
rigging
performance, and may void the product
warranty. Pan-tilt and full rotation yokes
are available for multi-angled and down-
fire applications.
ATTACH SAFETY CABLE
__Attach a safety cable to the integrated
eyebolt on the rear of each loudspeaker (see
Figure 4). The safety cable and hardware
are not included. Please consult a structural
engineer for the appropriate cable for the
load and application. The safety cable must
be secured to a suitable load-bearing point
separate from the loudspeaker mounting
point, with as little slack as possible, so as
not to develop undue kinetic force if the R
SERIES mounting were to fail.
Page 6
so
may
cause
safety
and
Installation and Operation Manual
2" OD
Rubber Gasket
8 x 32 mm SS Stud
(leave 3/4" sticking out)
Enclosure
Enclosure
R.35
Figure 3. Mount the loudspeaker to the yoke
R.15
Attach safety cable here
Figure 4. Attach the safety cable
Yoke
R.15
8mm SS Lock Washer
8mm SS Hex Nut
8mm SS Flat Washer
2" OD
Rubber Gasket
8 x 32 mm SS Stud
(leave 3/4" sticking out)
R.35
R.15COAX, R.35COAX, R.35-3896
Yoke
8mm SS
Hex Nut
8mm SS
Lock Washer
8mm SS Flat Washer