Anderson ANM76 Посібник з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Пальник. Anderson ANM76. Anderson ANM76 13 сторінок.

Anderson Thermal Solutions – ANM76 Burner Operation Manual

periodically check air or fuel nozzles of the burners to prevent to be blocked by dust, slag

or other materials.

ATTENTION：DANGER OF BEEN BURNT

When burner in operation, combustion is severe, so the burner must be fixed. Hoses or

cables in area of the combustion system must be suitable for high temperature, to prevent

high temperature failure or cause safety accidents. Burners should be periodically

inspected and cleaned. Copper wire brush may be used, if necessary, to clean burner head.

The burner system should be checked twice a year for safety operation.

Burner commissioning shall take care of ignition position, minimum and maximum output

position. Following interlocks will cause emergency stop, including gas low pressure, high

pressure or low combustion air pressure, as well as emergency stop is trigged, the main

power is out, UV signal failure or kiln safety conditions (such as high temperature limit, flue

system opening, etc.) will cause the burner lockout. Users need to know the maintenance

interval recommended by the manufacturer and the interval specified by national laws,

whichever is shorter.

4. Fuel Information

Following table shows combustion fuel specification of natural gas, safety rules must be

obeyed when operation carried out.

Fuel

Natural gas

Low Calorific value

35,900 [kJ/m

]

Composition

>98% CH

Reference conditions

1,013.25 mbar, 0°C

ANM76 series burner is a patented product of Anderson Thermal Solutions (Suzhou) Co.,

Ltd. This series of linear burners adopts a modular structure design concept and can be

configured to match shapes according to site requirements. It is an ideal choice for

generating large amount of clean and hot air. Applications include ovens, dryers, flue gas

incinerators and similar industrial equipment, and are widely used in heating industries

such as gypsum board. This type of burner is designed based on the proportional control of

gas and combustion air. Under normal operating conditions, the excess air is about 15-20%.

Anderson Thermal Soluions（Suzhou）Co., Ltd