Bosch V20-UL Інструкція з експлуатації, догляду та монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з експлуатації, догляду та монтажу для Сушарка Bosch V20-UL. Bosch V20-UL 28 сторінок. Bosch dryer user guide v20-ul
Також для Bosch V20-UL: Інструкція з експлуатації, догляду та монтажу (25 сторінок), Інструкція з експлуатації, догляду та монтажу (24 сторінок)

Друкувати сторінку

Bosch V20-UL Інструкція з експлуатації, догляду та монтажу

Exhaust air connection

You can use the exhaust air set

which can be obtained from

customer service or your local

dealer (WTZ1130).

Also any products which are

commercially available can be used

for the exhaust air duct:

flexible tubes,

galvanised sheet metal ducts or

tubes,

connection, transfer and

by pass adapters for use in flat

duct or tubular ducting

systems,

wall boxes for ventilation into

the open air or into an air shaft,

adapters for rectangular ducts,

rectangular ducts or plastic

tubesone way flap.

CAUTION

All materials must be

heat resistant up to 80 °C and

humidity resistant.

WARNING

1. To reduce the risk of fire, this

dryer MUST BE EXHAUSTED

OUTDOORS.

2. To reduce the risk of fire, do

not use the ductwork longer

than recommended.

3. DO NOT use a plastic or

non metal duct with this dryer.

4. DO NOT use a duct smaller

than 4 inches in diameter.

5. DO NOT use exhaust hoods

with magnetic latches.

6. DO NOT exhaust the dryer

into: a chimney, wall, ceiling,

concealed space of a building,

furnace cold air duct, attic,

crawl space, or any other

ductwork used for venting.

7. DO NOT install a flexible duct

in an enclosed wall, ceiling or

floor.

8. DO NOT crush or kink the

duct.

9. Do clean and inspect the

exhaust system on a regular

basis; at least once a year.

10. The exhaust duct must

terminate in a manner to

prevent back drafts or entry of

birds or other wildlife.

The Bosch dryers are intended to

be vented outdoors. To prevent

build up of moisture and

accumulation of lint indoors, as well

as to maintain maximum drying

efficiency, it is recommended that

the dryer is vented outdoors.

Position the exhaust air duct so

that there is no counter

pressure (e.g. from wind) on the

exhaust outlet.

Rear panel connection

The dryer is delivered with an

exhaust air outlet on the rear of the

appliance. The exhaust air vent on

the left hand side panel is closed

and covered.

Select the most suitable exhaust air

outlet.

Left hand side panel connection

1. Remove the cover from the side

panel.

2. Remove the bayonet ring from

the rear panel and attach it to

the side panel vent.

3. Close off the rear panel vent

with the cover.