Advanced Lighting Systems LiveLED 100 Інструкція з монтажу Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Освітлювальне обладнання Advanced Lighting Systems LiveLED 100. Advanced Lighting Systems LiveLED 100 10 сторінок.
Друкувати сторінку1.0 IMPORTANT SAFETY INSTRUCTIONS
•
SAVE THESE INSTRUCTIONS.
•
WARNING: RISK OF INJURY.
•
WARNING: THE HEAT SYNC COMPONENT OF THIS UNIT MAY BECOME HOT DURING
OPERATION. TAKE CAUTION WHEN HANDLING UNIT DURING OPERATION.
•
WARNING: RISK OF ELECTRIC SHOCK.
•
CAUTION: CONNECT ONLY TO A CIRCUIT PROTECTED BY A CLASS A GROUND FAULT
CIRCUIT INTERRUPTER
•
DO NOT BURY POWER CORD
2.0 Placement & Mounting Requirements
The LiveLED 100, is designed to operate in an indoor or outdoor environment. The proper voltage
required at the site is 110 - 240 VAC, 60/50 Hz. The unit draws 1 Amp at 120 volts. The LiveLED
100 is yoke mounted and is designed for operation in any orientation allowed by the yoke. The
LiveLED 100 must be adequately ventilated. Recommended operating temperatures are from -30
degrees F (-35 degrees C) to 140 degrees F (60 degrees C). The illuminator should be placed with
6-8" inches clearance on the sides and 12" inches of back clearance if unit is placed in front of an-
other unit. When more than one LiveLED is installed in the same location, provide each unit with the
same minimum clearances as noted above. Proper ventilation is absolutely necessary to maintain
LED life.
3.0 General Operating Instructions
With the unit properly installed, plug the illuminator power inlet cable into a suitable AC power
source. The LED modules will immediately light. The DMX color control system will cycle and then
stop on specific colors relative to whatever control settings the unit is currently set to. Unless oth-
erwise specified, units are shipped with color controls not preset. Color control setup is required to
achieve desired colors and effects. All color and effects control is activated using the 3 rotary knobs
on the unit (see control panel picture). The unit may operated as a stand alone single unit, in master/
slave configuration with other units or remotely using USITT DMX 512 control protocol generated by
an external unit. Consult the instructions for the DMX controller or other signal processor that will be
used for programming instructions. The DMX signal can be delivered through either of the XLR con-
nectors located on the bottom left of the illuminator (see control panel picture). The remaining con-
nector can be used as an output signal (in the case of a daisy chain) or left un-used (terminated).
A
L
S
,
•
dvAnced
ighting
yStemS
LLc
READ & FOLLOW ALL INSTRUCTIONS
519 L
R
•
S
c
incoLn
oAd
Auk
entRe
3
, m
56378
•
320 352 0088
inneSotA
t
•
320 352 0089
•
f
AdvAncedLighting
.
•
:
com
nASdAq
nexS