DREAMS SANA Посібник - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник для Внутрішнє оздоблення приміщень DREAMS SANA. DREAMS SANA 8 сторінок. Storage bed

Fitting Slat Frame - Use Pack 'B'

Stage

Note: Before fitting the mattress, carefully move slat frame up and down against the piston pressure

making sure it slides easily. It is better that two people do this making sure all the mechanism is free.

Note that it shall be stiff to start with. Place frame in the lower position then place mattress on top of

the slats. Depending on the weight of the mattress, the speed of the lift will vary when lifting or

lowering so be careful until you get used to the relevant speed with your own weight of mattress.

Always use the fabric handle to lift or lower the frame - keep fingers well away from the moving parts.

Push x2 Mattress Stoppers (8) into metal frame, they should go all the

way through the upper & lower metal sections.

Page 8 of 8

During this next step, the assistant should hold up the

slat frame.

On side panels (3&4), slide gas-lift piston stems (X)

onto the axles (Y) then fit the flange lock-nuts (H).

Tighten nuts with spanner (I) - DO NOT over-

tighten. A small gap is left so stems can move

freely - this is important - see sketch below.

(X)

(Y)

Note: Be very careful what

you store under the bed -

the top of an item, like a

suitcase or a box, must not

touch the slats or they shall

be damaged. Maximum

storage height is 185 mm.

SMALL GAP