DREAMS TRAFALGAR Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Внутрішнє оздоблення приміщень DREAMS TRAFALGAR. DREAMS TRAFALGAR 13 сторінок. Tv-audio bed, double, king & super king sizes

Друкувати сторінку

TV Installation Kit - Separate bag in Pack (A)

Stage

Bolt Sets (M6x25mm)

Self-Adhesive Pads - 3mm

(are inside accessory box)

TV Mounting Column (W).

Max load is 12 kg.

Max dimensions of TV that can be

fitted: 82 x 6.5 x 43.5cm (WDH)

(W)

REMO 2.10

Audio System

iii)

MEDIA CONNECTION LEADS

Stage

SUPPLIED & PACKED IN THE ACCESSORY BOX

4Mt

Aerial Lead

CONNECT CABLES CAREFULLY.

USE CABLE TIES & CABLE CLIPS TO KEEP ALL LEADS TIGHT

AS CLOSE TO BACK OF TV AS POSSIBLE - MAKE SURE THERE

ARE NO LOOSE WIRES THAT COULD BECOME TRAPPED.

Cable Ties

Please make certain that the 3.5mm black 90 deg

AUX plug is put into the

the rear of TV and NOT in another socket by mistake.

This shall route sound from TV to the bed speakers via

AUX Mode on the Remo 2.10 console (Green light).

Place TV on Platform (Y) as in sketch.

Occasionally the remote control eye or on/off switch

is mounted underneath the TV so please make sure

they can be operated correctly. It may be necessary

raise height of TV by using extra pads (b).

ii)

If TV height adjustment is necessary,

Adjust lid-lifter to maximum height of the

slot using Allen key (c) - loosen the

clamping screws (don't remove) & slide

curved lifter to top of it's slots. Gently lock.

Note: To fix TV, use the M6x25mm bolts &

washers (a) from the TV Installation kit that is

packed with the main hardware kit - this kit is

packed inside the accessory box. Use Allen

key (J) but do not overtighten.

If necessary, adjust mounting plates (X) by loosening the four domed

nuts (Z) and move plates up or down so bolts (a) are in line with the

VESA fixing holes on back of TV then tighten with spanner (d).

After final fitting of the TV, adjust lid-lifter back down so curve is 3mm

higher than top of TV.

Power Lead

2.8 Mt HDMI

Supplied with TV

Leads - x2 + 90º

Adaptor

Cable Clips

HEADPHONE socket on

Allen Key for Lid-Lifter - 2.5mm

Spanner (for 9mm Domed Nut)

HDMI 90º Adaptor

Use cable clip (27) on back of TV

to keep leads tight - make sure all

leads at rear of TV go into the

ducts and cannot get trapped

IDENTIFY HEADPHONE SOCKET

LIFT 3.5mm PLUG & PUT INTO

HEADPHONE SOCKET. IF

NECESSARY, CLIP LEAD TO BACK

OF TV SO IT CANNOT SNAG.

Page 7 of 13

Self-Adhesive

Pads (b)

(Y)

(Z)

(X)