Bosch WTW87561SG Посібник з монтажу та експлуатації - Сторінка 40

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Сушарка Bosch WTW87561SG. Bosch WTW87561SG 48 сторінок.

Друкувати сторінку

Help with the appliance

H e l p w i t h t h e a p p l i a n c e

Faults

Appliance does not start.

Creasing.

Water is leaking out.

Programme duration displayed

changes as drying progresses.

Laundry is not dried properly or

is still too damp.

The programme does not start Make sure that:

Drying taking too long.

Cause/Remedy

Check the mains plug and the fuses.

Load exceeded or incorrect programme selected for a type of fabric.

■

All the required information can be found in the programme

table.~ Page 23

Remove laundry from the drum as soon as the drying programme

■

has finished. Creasing occurs when clothing is left in the drum.

The appliance may be positioned at an angle. Level the

appliance.~ Page 13

Not a fault. The moisture sensor measures the residual moisture in the

laundry and adjusts the programme duration (with the exception of timed

programmes).

After the programme has ended, warm laundry feels damper than it

■

actually is. Spread out the laundry and let it cool down.

Adjust the drying time or increase the degree of dryness. This will

■

extend the drying time but the temperature will remain the same.

Select a timed programme to add extra drying time for laundry that is

■

still damp.

Select a timed programme for a small load.

■

Do not exceed the maximum load for a programme.~ Page 23

■

Clean the moisture sensor in the drum. The sensor may become cov-

■

ered in a fine layer of limescale or detergent and care product resi-

due, which then impairs its performance.~ Page 37

Drying has been interrupted as a result of a power cut, because the

■

condensation container is full or because the maximum drying time

has been exceeded.

Note: