Bosch WTW87569SN Посібник з монтажу та експлуатації - Сторінка 24

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Сушарка Bosch WTW87569SN. Bosch WTW87569SN 32 сторінки.

Faults and what to do about them

Faults

Drying time too long?

Display panel goes off

and Start button flashes.

Residual water in the

condensate container

despite the dryer being

connected to the con-

densation drain*.

Humidity in the room

increases.

Power cut.

Unusual noises when

drying.

The dryer feels cold

despite drying.

* depending on the model

If you cannot rectify the fault yourself by turning the dryer off and on, please

Note:

contact our after-sales service.

Cause/remedy

The fluff filter may be dirty and cause drying to take longer. Clean the fluff

■

filter.

If the air inlet on the dryer is blocked or not freely accessible, this may

■

increase the drying time. Make sure that the air inlet remains unobstructed.

If the ambient temperature is higher than 35 °C, this may extend the drying

■

time.

Insufficient air circulation in the room may increase the drying time. Venti-

■

late the room.

Not a fault. Energy saving mode is active ~ Page 7.

Not a fault. If the condensation drain is installed, residual water remains in the

condensate container due to the dryer's self-cleaning function.

Not a fault. Make sure the room is sufficiently ventilated.

The drying programme is interrupted. Remove the laundry and spread it out, or

restart the programme.

Not a fault. Noises are produced by the automatic cleaning of the heat

exchanger ~ Page 21.

Not a fault. The dryer can dry efficiently at low temperatures using a heat pump.