Comnet CWFE2SCM2 Посібник з монтажу та експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Конвертер мультимедіа Comnet CWFE2SCM2. Comnet CWFE2SCM2 12 сторінок. Commercial grade 10/100 mbps ethernet 2 port electrical-to-optical media converter
Також для Comnet CWFE2SCM2: Посібник із швидкого старту (4 сторінок), Посібник з монтажу та експлуатації (10 сторінок)
Друкувати сторінку
DIP-switch
The DIP-switch is used to configure operation mode for LLF (Link Lost
Forwarding) and operation mode for UTP/Fiber port. The default value of
DIP switch is OFF.
S/W No
1
2
3
4
Link Lost Forwarding (DIP-Switch 3): When LLF is enabled, it allows UTP
link failures to be reported to the fiber side and also allows a fiber link failure
to be reported to the UTP side. Therefore, a link loss forward feature is
provided in both UTP and fiber side.
Pure Converter mode (DIP-Switch 4): When the pure converter mode is
enabled (on), it operates with minimal latency. The transmission flow does
not wait until the entire frame is ready, but instead it forwards the received
data immediately after the data has been received. The UTP port should be
forced at 100M in this application. When DIP-Switch is in Switch Converter
mode (off), the converter function is same as Switch Hub.
[Note] Do not change the DIP-switch setting when UTP or fiber port is
transmitting or receiving data. It may cause some data errors. If you change
the DIP-switch setting, please power off the converter and power it on again
to make the setting effective.
Status
Description
ON
UTP 100Mbps Full Duplex mode
OFF
UTP Auto-Negotiate
ON
Fiber in Half Duplex
OFF
Fiber in Full Duplex
ON
LLF Enable
OFF
LLF Disable
ON
Pure converter mode
OFF
Switch Converter mode
5