DREAVER MZD-03 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Масаж DREAVER MZD-03. DREAVER MZD-03 16 сторінок. Foot spa massager

Press to set the temperature; each press to the button of the temperature "+" can

only increase by 1, and the maximum can only be up to 48C°; the button "-"can only be

reduced by 1 per press, and the minimum can only reach 35C°;

Perform corresponding actions in real-time according to the difference between the

water temperature and the pre-set temperature;

When the water temperature is lower than the pre-set temperature, the heating

functions will be automatically turned on;

When the water temperature reaches the pre-set temperature, the heating function

will be automatically turned off; and there will be a geluid sound "di di di".

The timing button of the remote control:

The default time of boosting is 30 minutes countdown;

Time setting key, the highest setting is 60 minutes, the lowest setting is 10 minutes;

The system will shut down immediately after the 30 minutes countdown and a beep

"di" is issued;

The bubble/red-light function part of the remote control:

Press the button to turn on the red-light function and bubble function in cycles;

The massage function part of the remote control:

Press the button to turn on the three modes of the massage function in cycles;

WATER TEMPERATURE CONTROL

When the water temperature < the set temperature 2C°, it will reheat. When the water

temperature > the set temperature, the heating will be stopped , and the water temperature

will be maintained by circulating heating;

REPLACE THE CONTROL BATTERY

Remove the battery box from the remote control and take out the original battery.

Install the CR2025 button battery on the battery box, please pay attention to the negative

and positive poles of the battery (positive electrode down). Install the battery box with

the battery on the remote control.

The remote control with a new battery.

D R EAVER - FOOT SPA MA SSAG ER