Comnet netwave NWKED Посібник із швидкого старту - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Передавач Comnet netwave NWKED. Comnet netwave NWKED 5 сторінок. Video encoder/decoder kit for use with netwave wireless ethernet
Друкувати сторінкуQUICK START USER GUIDE
INSTALLATION REQUIREMENTS
Shielded outdoor CAT 5 or better should be used for all out of plant Ethernet connection and should be properly grounded
through the PoE AC ground. Industrial grade shielded Ethernet cable is recommended to help prevent ESD damage commonly
experienced with outdoor installations. Visit www.comnet.net/comnet-products/cables
CONFIGURING NETWAVE
1. Connect an Ethernet cable from the port labelled as Ethernet on the Encoder or Decoder to either a laptop or a PC LAN port.
2. Connect the terminal block the provided power supply and connect to the Encoder/Decoder. Connect the power supply to a
power outlet. You should notice the red PWD LED illuminate.
3. Set the IP address of the laptop being used to configure Netwave to static and the subnet to 192.168.10.x/24 subnet.
4. Point the browser to the Encoder/Decoder IP address.
The default addresses are:
Decoder: 192.168.10.200
Encoder: 192.168.10.201
NOTE: Internet Explorer 11 in Compatibility mode is highly recommended.
5. A login prompt will pop up. Enter:
ID: admin
Password: 123456
6. To configure the Decoder login then Select Connection Settings and set the desired settings.
• Select Apply Settings
• Select Save
• Select Reboot to store settings.
7. To configure the Encoder login then Select the Setup Tab and make the necessary changes.
• Select Apply Settings
• Select Save
• Select Reboot to store settings.
DEFAULT CONFIGURATIONS
IP Address of Decoder Web Server
IP Address of Encoder Web Server
LAN Mode for Web Server
Web Server User ID
Web Server Password
Video Stream
NOTE: A Reset to defaults (performed on the ADMIN page) will erase all user configurations.
FIGURE 4 – TYPICAL APPLICATION
10/100
Ethernet
Monitor
Decoder
TECH SUPPORT: 1.888.678.9427
192.168.10.200
192.168.10.201
Static Addressing
admin
123456
MPEG4
NW1
NW1
Client
Access Point
(not included)
(not included)
Connection Type
Enable Audio In
Enable Control Data
Stream Port
Control Port
10/100
Video
Ethernet
Encoder
Camera
NWKED
TCP
Off
On
6002
6001
LEGEND
WIRELESS
CAT5
COAX
ETHERNET
VIDEO
INS_NWKED_QS_REV– 05/20/13 PAGE 4