Comnet FVR401 Інструкція з механічного монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з механічного монтажу для Мультиплексор Comnet FVR401. Comnet FVR401 4 сторінки. 4-channel digital video multiplexer 10-bit digital/short-haul
Також для Comnet FVR401: Посібник з монтажу та експлуатації (4 сторінок), Посібник з монтажу та експлуатації (4 сторінок)

INSTALLATION INSTRUCTIONS

WARNING: Unit is to be used with a Listed Class 2 or LPS power supply rated 9-12 VDC @ 1A.

WARNING: This unit should be installed in a restricted access location; available through the use of a lock and key or other means of security.

Access should be limited to service personnel who have been instructed about the reasons for the restrictions to the location. Any and all pre-

cautions should be taken and controlled by the authority responsible for the location.

IMPORTANT SAFEGUARDS:

A) Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environ-

ment may be greater than room ambient. Therefore, consideration should be given to installing the equipment in an environment compatible

with the maximum ambient temperature (Tma) specified by the manufacturer.

B) Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow required for safe operation of the

equipment is not compromised.

For Technical Support, Contact Your Nearest Communication Networks Office:

3 Corporate Drive • Danbury, CT 06810 • USA • Tel: 203-796-5300 • Toll Free: 1-888-678-9427 • www.comnet.net

8 Turnberry Park Road • Gildersome • Morley • Leeds, UK LS27 7LE • Tel: +44 (0)113 307 6400 • Fax: +44 (0)113 253 7462

4-CHANNEL 10-BIT DIGITAL VIDEO TRANSMITTER

NOTE: Remove Electrical Connector for Rack Mount Units

MULTIMODE

OR SINGLE MODE

OPTICAL FIBER

BLACK WITH WHITE STRIPE

BLACK

FVT401

INS_FVT/FVR401_REV–

06/09/09

Page 2