Electrolux EGC3310NOK1 Інструкція по встановленню та використанню - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція по встановленню та використанню для Варильна поверхня Electrolux EGC3310NOK1. Electrolux EGC3310NOK1 8 сторінок. Built-in hot plates
Друкувати сторінку
INSTRUCTIONS FOR THE INSTALLER
THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY REGISTERED GAS
INSTALLERS EXCLUSIVELY, IN CONFORMITY WITH THE REGULATIONS IN FORCE.
THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES TO PEOPLE,
ANIMALS OR THINGS, RESULTING FROM THE FAILURE TO COMPLY WITH SUCH PROVISIONS.
INSTALLATION
Installing the top
The appliance is designed to be embedded into
heat-resistant pieces of furniture.
The walls of the pieces of furniture must resist a
temperature of 75° C besides the room one.
The equipment must not be installed near
inflammable materials, such as curtains, cloths,etc.
Make a hole in the top of the piece of furniture,
with the dimensions indicated in fig.3, at a distance
of at least 50 mm from the appliance border to the
adjacent walls.
MODEL
EGC3320NOK
EGC3310NOK1
Any possible wall unit over the cook-top must be
placed at a distance of at least 760 mm from the
top.
It is advisable to isolate the appliance from the
piece of furniture below with a separator, leaving a
depression space of at least 10 mm (fig. 4).
If the hob is going to be installed on the top of an
oven, precautions must be taken to guarantee an
installation in accordance with current accident
prevention standards. Pay particular attention to
the position of the electric cable and gas pipe: they
must not touch any hot parts of the oven.
Moreover, if the hob is going to be installed on
the top of a built in oven without forced cooling
ventilation, proper air vents must be installed
to guarantee an adequate ventilation, with the
lower air entering with a cross section of at least
2
200cm
, and the higher air exiting with a cross
section of at least 60 cm
When installing built-in gas hob on top of stove
cabinet, please check that there is provision for
ventilation at the cabinet to ensure proper
operation of the gas hob.
Do not store any flammable materials, sprays or
pressurized containers inside the stove cabinet.
IMPORTANT NOTICE:
L (mm)
P (mm)
280
480
2
.
hob
Fastening the
Every hob is equipped with a special seal. A set of
hooks is also supplied for mounting the hob.
For the installation proceed as follows:
- Remove the racks and burners from the top.
- Turn the appliance upside down and lay the
seal S along the external border (fig. 5).
- Introduce and place the hob in the hole made
in the piece of furniture, then block it with the
screws of the fastening hooks C (fig.6).
Installation room
This appliance is not provided with a device for
exhausting the products of combustion.
Regarding room ventilation rules where appliance
is installed make reference to the legislation, in
conformity with the local regulations.
4