Electrolux EGC3322 Посібник користувача - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник користувача для Варильна поверхня Electrolux EGC3322. Electrolux EGC3322 20 сторінок. Electrolux hob
Також для Electrolux EGC3322: Посібник користувача (16 сторінок), Посібник користувача (20 сторінок), Посібник користувача (20 сторінок)

Друкувати сторінку

The by-pass screw

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the ad-

justment screw in.

• If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn.

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

8.5 Electrical connection

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug (if applicable).

• The appliance must not be connected

with an extension cable, an adapter or

a multiple socket. There is a risk of fire.

• Do not let the power cable to heat up

to a temperature of more than 90° C.

The cable should be guided by means

of clamps fixed to the side of the cabi-

net, in order to avoid any contact with

the equipment beneath the cooktop.

• Make sure that there is access to the

mains plug after the installation.

Electrical Requirements

Permanent electrical installation must

agree with the latest I.E.E. Regulations

and local Electricity Board regulations. For

your own safety the installation must be

done by a qualified electrician (e.g. your

local Electricity Board, or a contractor

who is on the roll of the National Inspec-

tion Council for Electrical Installation Con-

tracting [NICEIC]).

The manufacturer refuses to be

held responsible, if these safety

measures are not abided by.

Supply connections:

This hob has to be connected to 230 —

240 V ( 50 Hz) electricity supply.

Before carrying out the connection, make

sure:

The limiter valve and the electrical

system can take the appliance load

(see the rating plate)

The supply system is equipped with

an efficient earth connection in com-

pliance with the current standards

and regulations

The outlet or omnipolar switch used

for connection is easily accessible

with the appliance installed.

The appliance is supplied with a 3 core

flexible power cable requiring a 13 amp

plug fitted with a 13 amp or 3 amp fuse

dependent on the load. You must pur-

chase and install the plug.

The wires in the cord are coloured as fol-

lows:

Green and yellow

Blue

Brown

Replacement of the connection cable

Connect the green and yellow (earth)

wire to the terminal which is marked

with the letter 'E', or the earth symbol

, or coloured green and yellow.

Connect the blue (neutral) wire to the

terminal which is marked with the let-

ter 'N' or coloured blue.

Connect the brown (live) wire to the

terminal which is marked with the let-

ter 'L' and is always connected to the

network phase.

There must be no cut or stray strands of

wire present. The cord clamp must be

correctly attached to the outer sheath.

ENGLISH

- Earth

- Neutral

- Live