ATL IP 250 Посібник із швидкого старту - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для IP-телефон ATL IP 250. ATL IP 250 2 сторінки.

Друкувати сторінку

►

3. Plug the other end of the LAN cable into the network wall socket, switch or router. Note

If you have a PC already connected to the network port you wish to use, disconnect the PC

from this network port and reconnect it into the port marked "PC" on the IP 250.

►

4. Plug the mains adapter provided into a 240 Vac mains socket, and the 12Vdc power jack

into the socket located at the rear of the phone. Note If using POE please skip this step as

power will be provided to the phone via the LAN connection.

Note You will need a PC connected to the same network to configure your IP 250.

►

1. Allow the IP 250 to boot, once the phone is ready the date and time will be displayed

across the top of the screen.

►

2.1. DHCP NETWORK

Press the SET button and a menu should appear, now press 2. This will take you in the net-

work setup now press 1 three times. You should now see what is known as an IP address

and will appear in the format xxx.xxx.xxx.xxx, make a note of this. If there is no address

shown the network you are connected to is not using a DHCP server or the phone is not

correctly connected.

►

2.2. STATIC NETWORK

Connect the phone to a network with a DHCP Server to obtain an IP address. Once an IP

address has been obtained log into the phone via the web interface and configure it with a

static IP address. For more information please see the user manual.

►

3. Now that you have your IP address open up Internet Explorer on a computer that is

connected to the same network as the phone and in the address bar enter that IP address

that was obtained in step 2. A popup box asking for a username and password should now

be displayed. The default username and password are admin/voip

►

4. The homepage for the IP 250 should now be displayed. Click the SIP heading and then

enter the relevant details that you have obtained either from your network admin or your

ITSP into the address and port fields for the primary server and if you will be using an

outbound proxy then fill in this field as well. Click the Save SIP Settings button and reboot

the phone but pressing the reset button ensuring that Reset and execute Main Application

is selected.

►

5. Once the phone has rebooted log back into the phone (repeat step 3) and select the SIP

menu again. Now select User 1 from the menu and fill in the boxes for the primary server

using the details provided by your ITSP or network administrator. Now reboot your phone,

once again making sure Reset and execute Main Application is selected.

►

6. Your phone should now be ready to make calls. If your phone has successfully registered

your telephone number or CID name will appear on the phone below the date and time.

Making a call

Lift Handset

Dial a number on your sip network