Electrolux EGS6343 Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Варильна поверхня Electrolux EGS6343. Electrolux EGS6343 16 сторінок. Electrolux hob

Друкувати сторінку

this plate in the package supplied

with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure ad-

juster on the gas supply pipe.

7.3 Adjustment of minimum level

To adjust the minimum level of the burn-

ers:

Light the burner.

Turn the knob on the minimum posi-

tion.

Remove the knob.

With a thin screwdriver, adjust the by-

pass screw position.

The by-pass screw

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the by-

pass screw in.

• If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn (1/2

of a turn for Triple Crown burner).

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

7.4 Electrical connection

• Ground the appliance according to

safety precautions.

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the

local power supply.

• This appliance is supplied with a mains

cable. It has to be supply with a correct

plug, able to support the load marked

on the rating plate. The plug has to be

fitted in a correct socket.

• Any electrical component must be in-

stalled or replaced by the Service Force

Centre technician or qualified service

personnel.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is an access to

the mains plug after installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• The appliance must not be connected

with an extension cable, an adapter or

a multiple connection (risk of fire).

Check that the ground connection is in

conformity with the standard and regu-

lations force.

• The power cable must be placed in

such a way that it does not touch any

hot part.

• Connect the appliance to the mains

with a device that lets to disconnect the

appliance from the mains at all poles

with a contact opening width of mini-

mum 3 mm, eg. automatic line protect-

ing cut-out, earth leakage trips or fuse.

No part of the power cable must heat to a

temperature of more than 90° C.

Use clamps installed on the side of the

cabinet to prevent contact with the equip-

ment below the cooktop. See an example

of an optimal path in Figure.

Rigid copper pipe or flexible pipe in

stainless steel

7.5 Replacement of the

connection cable

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make

sure that the cable section is applicable to

the voltage and the working temperature.

The yellow/green earth wire must be ap-

proximately 2 cm longer than the brown

(or black) phase wire.

ENGLISH