Compact Light System CLS DMX16 Посібник користувача - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник користувача для Освітлювальне обладнання Compact Light System CLS DMX16. Compact Light System CLS DMX16 8 сторінок. 16 channels dmx light mixer
Друкувати сторінкуTrouble shooting diagram:
Fault Indication:
No lights in the leds when connecting
power to the DMX16.
When turning on all the Groups, the light
in the diodes is dimmed down.
The lamps that is connected to the DMX
chain is flashing and seems unstable.
There is no response on the DMX unit(s)
connected to the DMX16.
When selecting a new group, the faders
seems to not working.
The CLS DMX 16 is running the Chase
when the power is connected and there is
no light staying in led 1.
What to do:
Is the mixer in program-mode ? Push the
Prg knob. All the leds should flash.
Check if the power plug connected to the
mains ?
Try to take out the power and the DMX
plugs, wait 20 second, and connect it
again.
Any power in the connection ?
Connect a lamp to the power outlet. If it
light up, change power supply.
If it doesn't light up. Check fuse for the
power outlet circuit.
To small power supply.
Recommended input minimum is:
600mA 12V AC or DC. Polarity
unessential.
Always use good quality DMX cable with
a terminator at the last unit.
(120 Ohms resistor connected between Pin
2 and 3 in a XLR plug.) Check or change
the cables one by one.
Check the DMX channel selection on the
unit(s). Is it the same channel on the DMX
unit(s) than the one you are working on ?
The DMX16's groups will remember the
last used position and you need to find the
point where it was last time. Move the
fader slowly till you see some changing of
the light. This will activate the fader.
The CLS DMX 16 has a built in function if
the power fails. It will start the Chaser as it
was running when the power comes back if
it was in program-mode when the power
was turn off. Press Prg to go to mix-mode.
8