Andrew CommScope Argus Інструкція з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Антена Andrew CommScope Argus. Andrew CommScope Argus 8 сторінок.

Andrew CommScope Argus Інструкція з експлуатації
Bulletin A997-0083 · Revision H · March 2015 page 3 of 7
Do not install near power lines. Power lines,
telephone lines, and guy wires look the same.
Assume any wire or line can electrocute you.
Installation Instructions – Adjustable Downtilt Mounting Kit
T-029-GL-E, T-041-GL-E, T-045-GL-E, T-095-GL-E
Assemble mounting kits as per Figure 2 and 3 of this document.
1. Attach the mounting kit assembly to the antenna, before trying to clamp
the brackets to the pole.
2. Downtilt angles in 1° increments can be obtained with the correct
adjustment of the tilt arm bracket.
tilt arm to the pivot bracket which mates against the mounting pole, as
shown in Figure 4. The first hole is for 1° downtilt*, with each consecutive
hole resulting in an increased inclination of 1°.
(*Note for the T-045-GL-E kit the tilt is 0° then 2° - 10° in 1° steps.
For the T-095-GL-E kit the tilt starts at 0° and increments in 3° steps)
and bottom mounting bracket on the pole can be adjusted.
verify downtilt angle as required.
The clamp brackets can clamp pipe diameters between 50 mm (2") & 115mm
(4.5"). For typical installations of antennas up to 1575mm (62") long the minimum
recommended pipe diameter is 60mm (2.4"). For antennas over 1575mm (62")
long the minimum recommended pipe diameter is 75mm (3").
Instruction Manual, 353mm (13.9") Profile Panel Antennas
Do not install on a wet or windy day or
when lightning or thunder is in the area.
Do not use metal ladder.
Downtilt can be achieved by aligning the corresponding hole in the
For finer downtilt angle adjustments the distance in between the top
For 0° downtilt the tilt arm may be stowed as show in Figure 4.
An inclinometer or other angular measuring device may be used to
USE MOUNTING
BRACKETS FOR
LIFTING AS SHOWN
Wear shoes with rubber soles and heels.
Wear protective clothing including a
long-sleeved shirt and rubber gloves.