Dresser Texsteam TA 0179 Посібник з монтажу та експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Контролер Dresser Texsteam TA 0179. Dresser Texsteam TA 0179 8 сторінок. Multipoint injection controller
Друкувати сторінку
Servicing & Troubleshooting
WARNING
- EXPLOSION HAZARD -
SUBSTITUTION OF COMPONENTS MAY IMPAIR
SUITABILITY FOR CLASS 1, DIVISION 2.
WARNING
- EXPLOSION HAZARD -
DO NOT DISCONNECT EQUIPMENT UNLESS POWER
HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN
TO BE NON-HAZARDOUS.
WARNING
Beware of potentially harmful chemicals ejecting from
the pump head when you are opening the priming valve.
Take appropriate precautions to protect your self from high
temperature and/or harmful chemical exposure.
WARNING
This equipment can be installed in areas that
may contain gases or vapors which can lead to
oxygen depletion and/or personnel asphyxiation. Additional
protection and warnings should be
followed and posted in such installations.
For fluid leaks check all fittings make sure there are no loose
connections, and tight fittings.
For solenoids valve not operating, check electrical connections.
The following spare parts are available if replacements are need
it:
Part #
SP2216
RELAY MODULE, DIN-RAIL MNTD
TERMNL BLCK,12VDC 6AMP
TB 1774
MANIFOLD VALVE ASSY, 4 STATION
TA 1773
MANIFOLD VALVE ASSY, 3 STATION
TA 1772
MANIFOLD VALVE ASSY, 2 STATION
TC 2400-KIT
KH401XF02J1BF5 - Solenoid Repair Kit
Multipoint Injection Controller
Description
Emergency field repairs by authorized service technicians are
strongly advisable. Repairs made by un-authorized technicians
will void any warranty. To assure safety of equipment and
personnel, only Dresser recommended replacement parts
shall be installed. And above all, disconnect power from the
iCIP® pump before servicing. Damage to wiring and operating
equipment may be avoided with careful reviewing the
operating and installation procedures document by qualified
personnel. At all times, operating safety of electrical equipment
is imperative to avoid injury to personnel.
IMPORTANT
Read this instruction document with special attention
to warnings, cautions and safety concerns.
FAILURE TO ADHERE TO THESE INSTRUCTIONS
COULD RESULT IN SAFETY HAZARDS WHICH MAY
RESULT INJURY TO PERSONNEL, MOTOR/CONTROLLER
DAMAGE OR OTHER ELECTRICAL EQUIPMENT.
Doubts or reservations with regards to installations
or maintenance with reference to connecting your
"Solar Powered" Chemical Injection Pump system should
refer to the detailed sections supplied in this manual.
For additional instruction, classification or assistance,
contact an authorized Service Center.
WARNING
Avoid personnel injury involving equipment that is in motion.
Always remove or disconnect power prior to service to
the motor, motor controller, batteries, charge controller,
solar panels.
Texsteam Pumps Multipoint Installation Manual 7