Electrolux DD 8795 Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Вентиляційна витяжка Electrolux DD 8795. Electrolux DD 8795 20 сторінок.

Filter checking device

The cooker hood is fitted with a device which indicates when the filter

must be cleaned or replaced.

Usually the device, which signals when the carbon filter needs

maintenance work, is deactivated.

To activate it, proceed as follows:

Switch off the cooker hood.

Press and hold the knob for approximately 5 seconds.

The L2 LED begins to flash in green and after approximately 2

seconds the L2 LED will also begin to flash in orange, to indicate that

the device, which indicates when it is necessary to perform carbon

filter maintenance, has been activated.

L2 LED - grease filter indicator

The LED lights up in green when the grease filter needs to be cleaned;

this happens approximately every 40 hours of operation.

Every time the cooker hood is used, check whether the L2 LED is lit.

L2 LED - carbon filter indicator

The LED lights up in orange when the carbon filter needs to be

cleaned/replaced; this happens approximately every 160 hours of

operation.

Every time the cooker hood is used, check whether the L2 LED is lit.

Resetting the filter saturation warning

After cleaning or replacing the filters, switch on the cooker hood at any

suction speed (power), then press and hold the knob for more than 3

seconds, until you hear a beep indicating that the reset procedure has

been performed successfully. The L2 LED and the cooker hood both

switch off.

In some situations (for example, when the L2 LED is indicating that

the grease filters and the carbon filter are saturated), the procedure

described above must be repeated.