Electrolux DD 8891 Посібник з експлуатації та встановлення - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з експлуатації та встановлення для Вентиляційна витяжка Electrolux DD 8891. Electrolux DD 8891 16 сторінок.

Друкувати сторінку

Electrolux DD 8891 Посібник з експлуатації та встановлення

For the installer

• When used as an extractor unit, the hood must be fitted with a

150mm diameter duct.

• When installing the hood, make sure you respect the following

minimum distance from the top edge of the cooking hob/ring

surfaces:

electric cookers

gas cookers

The hood can be installed above these heights but for optimum

performance it should be installed at the distance quoted for the

appropriate heat source.

• The national Standard on fuel-burning systems specifies a maximum

depression of 0.04 mbar in such rooms.

• The air outlet must not be connected to chimney flues or combustion

gas ducts. The air outlet must under no circumstances be connected

to ventilation ducts for rooms in which fuel-burning appliances are

installed.

• The air outlet installation must comply with the regulations laid down

by the relevant authorities.

• When the unit is used in its extractor version, a sufficiently large

ventilation hole must be provided, with dimensions that are approxi-

mately the same as the outlet hole.

• National and regional building regulations impose a number of

restrictions on using hoods and fuel-burning appliances connected

to a chimney, such as coal or oil room-heaters and gas fires, in the

same room.

• Hoods can only be used safely with appliances connected to a

chimney if the room and/or flat (air/environment combination) is

ventilated from outside using a suitable ventilation hole approxi-

mately 500-600 cm

being created during operation of the hood.

• If you have any doubts, contact the relevant controlling authority or

building inspector's office.

• Since the rule for rooms with fuel burning appliances is "outlet hole

of the same size as the ventilation hole", a hole of 500-600 cm

which is to say a larger hole, could reduce the performance of the

extractor hood.

• If the hood is used in its filtering function, it will operate simply and

safely in the above conditions without the need for any of the

aforementioned measures.

• When the hood is used in its extractor function, the following rules

must be followed to obtain optimal operation:

500 mm

650 mm

large to avoid the possibility of a depression