Electrolux E36WV60PPS Посібник з монтажу, експлуатації та догляду - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з монтажу, експлуатації та догляду для Вентиляційна витяжка Electrolux E36WV60PPS. Electrolux E36WV60PPS 12 сторінок. 30"(76.2 cm) and 36"(91.4 cm) range hood
Також для Electrolux E36WV60PPS: Посібник з монтажу, експлуатації та догляду (12 сторінок)
Друкувати сторінкуBlower Motor Systems Installation
For recessed bottom cabinet only
If the cabinets have front, side or back trim, make 2
wood shims the width of the trim and attach them to
the cabinet bottom recess on both sides.
Installation to wall
(Horizontal duct- 31A"x10" Rectangular)
•
Use the diagram or the hood as a template and
mark the locations on the wall for ductwork,
electrical wiring and keyhole screw slots.
View From
1" x6" Min.
Mounting
Support
1-3/16"
permanent
mounting hole /
WALL
13-5/6"
(30" Hood)
16-13/16_'(36
' Hood)
6-13/16"(30"Hood)
T'(36"
Hood)
_
/
Center line
13-5/6"
(30'
Hood)
4
16-13/16"
(3e'
Hood)
I1_
1
6-13/16"
(30"Hood)
7' (36"
Hood) _'
_]1_\
\
permanent
(30"
ModeE)
_
\
(36"
ModeE)
mounting hole
Install framing for hood support
°
If drywall is present, mark the screw hole
locations. Remove the template.
°
Cut away enough drywall to expose 2 vertical
studs at the holes location indicated by the
template. Install two horizontal supports at least
4" x 2" between two wall studs at the bottom and
upper mounting holes installation location.
°
The horizontal support must be flush with the
room side of the studs. Use cleats behind both
sides of the support to secure to wall studs.
°
Reinstall drywall and refinish.
IMPORTANT- Framing must be capable of supporting
100 Ibs.
•
Cut holes at marked locations for duct and
electrical wiring.
•
For the vertical duct, cut out 3A"extra toward the
front of the cabinet so you can move the duct
freely when installing the hood.
•
It may also ease installation by cutting the hole
10W' instead of 10".
°
Drive a mounting screw (from the hardware
packet) partway into each center of the narrow
neck of the keyhole slots marked on the cabinet
bottom.
°
Fix the wiring conduit to the hood.
°
Slide the hood back against the wall. Tighten the
mounting screws. Be sure the screw heads are in
the narrow neck of the keyhole slot.
°
Connect Ductwork to hood.