AirTech ATS-100 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Радіо AirTech ATS-100. AirTech ATS-100 8 сторінок. Land mobile radio

Operation

1. Power on / off and Volume Control:
Rotate the Power on/off and Volume Control Switch ⓐ
clockwise to turn power on, then the LED lights orange
and power–up tone is generated after about on second,
indicating the transceiver has passed the self–diagnostic.
When you turn on the transceiver, it comes same
channel and function with your last using. Rotate this
switch ⓐ
clockwise to increase the volume or
counterclockwise to reduce the volume. Rotate it ⓐ
counterclockwise fully to turn power off.
2. Channel Selection:
Press up/down button, to desired channel.
3. Transmit:
Hold down the PTT Button ⓜ and talk into the MIC at 1-
2 in distance. The LED lights red on transmitting.
Release the PTT button ⓜ to receive.
4. Receive:
Choose the desired channel by press up/down button ⓗ ,
ⓛ. The LED lights green on receiving. In case the signal
doesn't match the sub–tone the green LED will blink.
5. Monitor:
Press to monitor. Pressing the monitor button for more
than 2 seconds will cause continuous monitor condition.
To release the monitor mode, press and release the
monitor button quickly.
6. Scan
1). Press and hold the function button and up
button to start scan.
a. Scan type will be priority type, else normal type
If the radio is programmed in priority channel,
scan.
b. If priority type scan, the scan has stopped on a
non priority channel there will be skips in the
audio while the radio checks the priority
channel. During priority scanning you may talk
c. on the last busy channel by pressing the
function button and up button. After completing
the conversation, restart scan.
d.
To delete a busy channel from scan, press
down button. If the up button is pressed, the
scan will restart but stop again if the channel
continues to be busy.
7. Transmit operation during scan
①. If the radio is programmed in ptt channel at
scanning is home channel: TX will occur on the
channel the scan started.
②. If the radio is programmed in ptt channel at
scanning is last busy channel: TX will occur on the last
busy channel
8. TX ANI
If the radio was initially programmed for this feature
pressing the PTT will cause a DTMF code to be send
that can identify the sending radio.
9. 2/5 Tone Decode (Selcall)
During initial radio programming by the technician this radio
can be configured for several different types of decode
operation. If a channel is selected that has Selcall
activated the radio will be muted until the proper signal is
received. When this occurs the radio can sound a ringing
type alert signal or a voice message maybe heard.
Depending upon the initial programming, pressing the
PTT may cause an automatic identifier to be sent. When
programmed for Selcall pressing the monitor and function
buttons at the same time can cause the Selcall mode to
be cancelled and generate an automatic identification.
Please have your radio technician or dispatcher fully
explain this operation.