Atlantic MD1250 Посібник з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Водяний насос Atlantic MD1250. Atlantic MD1250 6 сторінок. Md-series
Також для Atlantic MD1250: Посібник з експлуатації (17 сторінок)

Друкувати сторінку

• CAUTION:

THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND CIRCUIT INTERRUPTER.

• CAUTION:

THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.

• WARNING:

RISK OF ELECTRIC SHOCK - THIS PUMP IS SUPPLIED WITH A GROUNDING CONDUCTOR AND

GROUNDING-TYPE ATTACHMENT PLUG. TO REDUCE THE RISK OF ELECTRIC SHOCK, BE CERTAIN

THAT IT IS CONNECTED ONLY TO A PROPERLY GROUNDED, GROUNDING TYPE RECEPTACLE.

Electrical Safety

• Electrical wiring should be installed by a qualified electrician in accordance with all

applicable safety regulations. Incorrect wiring can lead to a pump malfunction, electrical

shock or fire.

• Pumps should operate on a designated, 110/120 volt circuit.

• Pump must be protected by a ground fault circuit interrupter (GFCI).

• Pump must be plugged into a standard, properly grounded, three pronged outlet.

Safety Instructions

ATTENTION

Fig. 1

• Do not lift, lower or handle the pump by pulling on the electrical cord. Make sure the

electrical cable does not become excessively bent or twisted and does not rub against a

structure in a way that might damage it. (Fig. 1)

• Always disconnect the power supply before doing any maintenance or placing your hands

into the water to which this pump is immersed. (Fig. 2)

• The submersible pump should not be used if the electrical supply cable is damaged in

any way. If a cable with damaged insulation is submerged in water, there is danger of

water seeping into the pump motor and causing a short. The electrical cable cannot be

replaced. If the cord is damaged, the pump should be discarded. Altering the electrical

cable in any way will void the warranty. (Fig. 3)

Operation

• Mag Drive Series pumps are for use in water only. Water temperature should never

exceed 95˚ F (35˚ C).

Make sure the pump works at a proper water level. Do not

operate the pump without water. If so, the pump should be

turned off immediately and check.

Fig. 2

Fig. 3