Aleratec 260206 Посібник із швидкого старту - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Дисковий дублікатор Aleratec 260206. Aleratec 260206 16 сторінок. 1:15 blu-ray/dvd/cd tower duplicator sa

Друкувати сторінку

Unpacking the Unit

Your system was shipped in one box and contains the 1:15 Blu-ray/DVD/CD Tower

Duplicator SA and cables.

Carefully open the box and remove the top protective foam padding. Remove the

contents with care to avoid damage.

Note: It is important to keep the original shipping container and

packaging. In the event you misplace your packaging and need to

ship the 1:15 Blu-ray/DVD/CD Tower Duplicator SA, you should first

contact technical support to purchase a new shipping container.

Shipping the 1:15 Blu-ray/DVD/CD Tower Duplicator SA without

proper packaging will void your warranty.

Connect the Cables and Apply Power

Plug power cords into the two power supplies of the 1:15 Blu-ray/DVD/CD Tower

Duplicator SA, also located on the rear side. Make sure the red switches are set to

match your local voltage. Plug into power outlets.

If you'd like to access the unit's internal HDD, plug the USB 3.0 Cable into the USB

connector located on the center rear of the 1:15 Blu-ray/DVD/CD Tower Duplicator

SA. Connect the other end of the USB cable into an available USB 3.0 or 2.0 port

on your PC.

Note: Use only with a USB 3.0 or 2.0 port. This system cannot be used

with USB 1.1, as this will greatly affect system performance. If windows

displays a message that a fast USB device is detected on a slow USB

port, then you will need to upgrade your computer by adding a USB 3.0

or 2.0 port.