Electrolux ERHC1238S Посібник з встановлення та експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з встановлення та експлуатації для Вентиляційна витяжка Electrolux ERHC1238S. Electrolux ERHC1238S 16 сторінок. Canopy cooker hood
Також для Electrolux ERHC1238S: Посібник з встановлення та експлуатації (14 сторінок)
Друкувати сторінку
mAINTENANCE ANd CLEANING
WarnIng!
Before maintenance or cleaning is carried out,
the canopy cooker hood should be disconnected
from the main power supply. Ensure that the cooker
hood is switched off at the wall socket
and the plug removed.
WarnIng!
External surfaces are susceptible to scratches and
abrasions, so please follow the cleaning instructions
to ensure the best possible result is achieved without
damage.
stainless steel surface
These instructions must be followed to avoid a fire risk.
Clean stainless steel surfaces using non-abrasive cleaning
products that are specifically for use on stainless steel.
To ensure best results also use an even pressure and
follow the grain of the stainless steel. Use of a soft cloth
reduces the risk of scratching. If the cloth is wet ensure
that a dry soft cloth is used to wipe down the surface
again reducing the risk of any surface rust appearing.
cleaning grease filters
The filters can be cleaned by hand or dishwasher. After
cleaning ensure the filters are completely dry before
refitting. Grease filters must be removed every four weeks
(maximum) for cleaning to reduce the risk of fire.
• B y hand Soak in warm water and some washing up
liquid. For stubborn grease stains use a soft nylon
brush to help remove these stains.
• I n a dishwasher Ensure that placement of the
filters is made so as to not impede the function of
the dishwasher spray arm. Washing the filters in
a dishwasher may cause discolouration over time
although it will not effect their performance.Filters
should be washed separately to crockery and other
kitchen utensils.
removing filters
Remove filters by pulling down the latch to disengage the
lock pins. (Fig. A)
As lock pins are disengaged pull the filter slightly toward
you and then lift the filter up slightly to clear the bottom
filter support panel. (Fig. B)
removing filter support panels
To remove bottom filter support panel, hold the panel at
each end and lift, then push the panel in. (see arrows in
Fig. C). This will disengage the panel support pins to allow
removal of the panel (Fig. C)
Do not use the cooker hood without
filters installed.
Do not clean the canopy cooker hood with water
using a hose or high pressure cleaner.
inner panels and trough
After each use the inner panels and trough should be
wiped clean with non-abrasive cleaning products to
prevent excessive build up of oils/grease.
WarnIng!
Beware of edges
Filter
Fig. B
1
Lift
Lockpin
Latch
Outer filter
Inner filter
Fig.A
Bottom
filter
support
panel
Bottom filter
support panel
3
2
1
Fig. C
2
Push in
3
Remove
9