Electrolux GL series Використання - Сторінка 38

Переглянути онлайн або завантажити pdf Використання для Вентиляційна витяжка Electrolux GL series. Electrolux GL series 45 сторінок.

Друкувати сторінку

Interval function by controls (not possible for model WOSL90X):

→

, ... →

Keep pressing at the same time the push

button

and

: the led point of the first

speed will switch on, press again the push

button

, the light indicator will show the

following for the speeds of the motor

2→3→1→2→3 ...;

Keep pressing within 5 seconds the push

button

and

to confirm the speed for

the motor you wish for the interval function.

Setting of the interval function by the remote control:

→

, ... →

Press the push button

button the light indicator will show the following for the speeds of the motor 2→3→1→2→3

...;

Press within 5 seconds the

the interval function.

By pressing any push button, light excluded, the interval function is excluded.

The remote control has a battery (type 23 A). When the battery is exhausted you need to:

loosen the 2 screws on the rear part and remove the cover; take the battery out and replace it

with one with the same characteristics.

Close the cover again and tighten the screws.

Follow National norms for waste disposal of exhausted batteries.

SATURATION INDICATORS OF GREASE FILTERS AND CARBON FILTERS

The hood is delivered standard in suction use: if you wish to use the hood in filtering

version it is necessary to set this function.

When the grease filters need to be cleaned, you have a saturation indicator for the grease

filters and, if the hood is set for filtering use, when the carbon filters need to be

replaced/regenerated you have a saturation indicator for the carbon filters.

Saturation indicator alarm for the grease filter: acoustic signal with working motor and the point

of the led of the push button

Clearing the saturation indicator alarm for the grease filter: with the motor off press twice the

push button.

Saturation indicator alarm for the carbon filters: acoustic signal with working motor and led of

the

push button is flashing.

Clearing of the saturation indicator alarm of the carbon filter: press twice the

Setting of the filtering use: if the suction function is set up (standard delivery), with motor and

lights off keep pressing for 5 seconds the push buttons

will switch on for 5 seconds.

: the light indicator will show first speed, press again the

push button to confirm the speed for the motor you wish for

is flashing.

→

Keep pressing at the same time the push

button

and one of the speeds

at which you wish to set the interval function.

That is

Press

and

for the first speeed

Press

and

for the second speeed

Press

and

for the third speeed

Press within 5 seconds the

confirm the speed for the motor you wish for

the interval function.

; the led point of the push button

push button to

push

push button.