Electrolux ICON RH36PC60GS Посібник з монтажу, експлуатації та догляду - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник з монтажу, експлуатації та догляду для Вентиляційна витяжка Electrolux ICON RH36PC60GS. Electrolux ICON RH36PC60GS 19 сторінок. Range hood
Також для Electrolux ICON RH36PC60GS: Каталог заводських деталей (4 сторінок), Технічні характеристики продукту (2 сторінок), Каталог запчастин (4 сторінок)
Друкувати сторінку
Installing the hood
10
10
10
10
10
Place the template in the ceiling
considering the instructions for
ceiling support structures.
16 assembly screws
Attach a second vertical
support set to adjust the
vertical distance.
Attach the assembly to the
support fixed on the ceiling
Assure with screws (16)
Place lower duct covers
using one plastic bracket at
each vertex. (4 needed)
Mark with a pencil the hole
locations for screws and duct in
the ceiling (see also next page)
Insert the plastic gaskets on
each side of the hood.
(rear and front)
All version:
click !
Perform the electrical
connection.
Vent hood ONLY
Perform the ductwork
connection.
Installation with optional
recirculation kit.
Install the recirculation kit and
connect air deflector to transition
SEE NEXT PAGES
FOR FURTHER DETAIL
The lower duct cover shall
be secured to rangehood by
4 screws.
4 wood screws
Fix the upper horizontal
support with 4 wood screws.
Place the Glass Canopy onto
the hood. 2 people are
recommended to do this.
Attach the vertical duct cover
supports using 4 screws. Place
each spring using a screw by side.
Instal the grease filter and turn power on at service
panel. Check operation of the hood.
IMPORTANT: If the hood doesn't switch ON, before
calling for service, check if the internal General ON/
OFF Pushb-utton Switch is switched ON.
Frontside of the hood
Back side of the hood
8 assembly
screw
(B)
(A)
16 assembly screws
Attach the vertical supports (inf)
(A) to the hood. Then attach
horizontal support (B) (inf)
2 /side
Place glass brackets using 2
screws by side.
Place upper duct covers
sliding through until spring
sounds click . Then verify
General ON/OFF
Push button Switch