Atlantic Ultraviolet 10-0504A Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Системи фільтрації води Atlantic Ultraviolet 10-0504A. Atlantic Ultraviolet 10-0504A 20 сторінок.

Друкувати сторінку

ROUNDING

NSTALLATION

USING BALLAST NO

10. Ground Kits are shipped with each MINIPURE

10-0504A and is used to permanently connect a ground wire from the water purifier chamber to a known good ground.

We recommend checking with local codes or a licensed electrician in your area to determine the best grounding point to

attach the ground kit for your installation. An electrician can also measure the resistance between the water pipe and an

electrical outlet ground to insure your ground selection is correct.

Placement: Select a location that is visible as well as accessible. Connect the ground strap to a known good ground or a

water pipe that is metallic, with no intervening plastic fittings between it and the power ground.

Installation: Once a proper ground point has been determined, fasten the ground to the water purifier chamber as shown and

described below.

If you receive a 230v 50/60Hz water purifier, or ballast for a water purifier using ballast no. 10-0504A and a grounding kit is

not present in the carton please contact the factory with your order information and we will send you the correct grounding

kit for your application.

OOLS

EQUIRED

•

7/16" Wrench

•

10mm Wrench or Universal Pliers

•

Continuity Tester

Step 11 - Wrap Strap Tight Around Pipe

Step 14 - Install Nut on Stud

WARNING: To insure proper operation and safety of your water purifier, your unit must be

grounded to a known good ground.

: MIN-6

.10-0504A

Step 12 - Insert Bolt Through Both

Copper Holes & Tighten using a 7/16"

Wrench

Step 15 - Slide Ring Terminal Wire

Assembly onto Stud & Lock Washer

over Ring

MIN-9 230

50/60H

AND

Model MIN-6 and MIN-9 230v 50/60Hz water purifier using ballast

Step 13 - Insert Wire Into Hole & Install

Bolt / Tighten Bolt against Wire using

10mm Wrench, Ensure all is Secure

Step 16 - Install Nut on Stud against

Washer & Tighten with 7/16" Wrench