Drieaz F571-110V Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Осушувач повітря Drieaz F571-110V. Drieaz F571-110V 9 сторінок. Cube dehumidifier

Друкувати сторінку

CONTROL PANEL

ON/OFF

Press and release to turn unit on or off.

DISPLAY MENU

Press to select next item in menu. Menu item

will show in display.

Press to toggle or select values in menu

SELECTION /

displayed.

UP KEY

PURGE PUMP

Press and release to start purge. Display will

count down seconds remaining until purge is

complete.

your dehumidifier away from obstructions, and keep it

away from anything that could block airflow into and out

of the unit. For more information about creating an

optimum drying environment, contact your local

distributor.

Set up drain hose

Unwrap the entire hose and place the unattached end in

a sink, drain, bucket or outdoors – anywhere that water

can drain out safely. If you use a bucket or other

container for water collection, check it regularly to

prevent overflows. Verify hose fitting is attached to short

hose exiting the unit.

NOTICE: Uncoil and straighten the entire drain hose. Do

not leave any part of the hose coiled and do not place

the end of the hose higher than 6 m above the bottom of

the unit. Also check for kinks or other obstructions that

might restrict the flow of water. Obstructions may cause

a water backup and result in overflows.

Plug in electrical cord

The unit should be plugged into a 230V/50Hz or

110V/50Hz outlet depending on the model.

Startup display and normal display modes

When unit is first plugged in to AC power, the control

panel display will briefly cycle through a series of

readouts. This is part of the unit's self-diagnosis

procedure and no user intervention is required.

07-02282A F571-230V & F571-110V

PURGE PUMP

DISPLAY

SELECTION /

UP KEY

Fig. A: Parts Identification

Carry handles

Remove/Insert

air filter here.

Air inlet

Cord and

hose storage

compartment.

Turn the unit on

The control panel has a display and a touchpad with four

keys. Press the

ON/OFF to turn the unit on. The unit

will now go through a compressor delay countdown (up

to sixty seconds in duration) and an automatic

diagnostics process.

Once the compressor delay countdown and self-

diagnostics are complete, the display will switch to

normal display mode.

UNIT ON 00 HRS

INLET 00°C / INLET 00%

The first line of the display shows the total number of

hours the unit has been in operation. This value may be

reset to zero to track job hours (see "Job Hours Reset"

below). The second line of the display alternates

between inlet temperature and inlet humidity.

User Settings Menu

A number of display settings may be changed by the

user. System information can also be displayed. These

items are accessed by pressing

Each press of the key will display the next parameter.

When you reach the parameter you wish to adjust, press

MENU SELECTION to increase the value. Press

DISPLAY MENU again to accept the setting and re-start

the display cycle.

Note that only menu items followed by a greater-than

symbol ( > ) may be adjusted.

Air outlet

(both sides)

Control

panel

Air outlet

(both sides)

DISPLAY MENU.

Legend Brands Europe Holdings Ltd.